Flying below VAPP - What to do ?
Thread Starter
Join Date: Feb 2005
Location: TANZANIA
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Flying below VAPP - What to do ?
on approach with auto thrust on , you find speed going below VAPP or even getting to VLS , what do you do to recover back to your VAPP ?
Thanks
Thanks
Join Date: Feb 2000
Location: gashbag
Age: 53
Posts: 558
Likes: 0
Received 0 Likes
on
0 Posts
I have to assume you are talking about one of those death busses, otherwise you could simply mover the thrust levers to an appropriate position, you know, like a pilot
Momentarily advancing the thrust levers forward of the detent is perfectly fine.
Just make sure you are in a modified Aircraft otherwise below 100' AGL it will get interesting when you put them back All of ours are modded and if required I've been known to employ this method when I see IAS heading south and the A/T slow. Seems to work ok.
Just make sure you are in a modified Aircraft otherwise below 100' AGL it will get interesting when you put them back All of ours are modded and if required I've been known to employ this method when I see IAS heading south and the A/T slow. Seems to work ok.
A330 FCTM quote with regards to loss of speed:---
In gusty wind conditions, the A/THR response time may be insufficient to cope with an instantaneous loss of airspeed. A more rapid thrust response can be achieved by moving the thrust levers above the CL detent (but below MCT). The thrust will quickly increase towards the corresponding TLA. The A/THR remains armed and becomes active immediately the thrust levers are returned to the CL detent. Therefore, the thrust levers should be returned to CL detent as soon as there is a positive speed trend. However, there are two important points to note:
‐ Selecting the thrust levers to the TOGA detent, even momentarily, will engage the Go-Around mode,
and. ‐ In some aircraft selecting the thrust levers above the CL detent below 100 ft RA will disconnect the A/THR. In this case, returning the thrust levers to the CL detent will set climb thrust. Refer to FCOM DSC-22_30-90.
In gusty wind conditions, the A/THR response time may be insufficient to cope with an instantaneous loss of airspeed. A more rapid thrust response can be achieved by moving the thrust levers above the CL detent (but below MCT). The thrust will quickly increase towards the corresponding TLA. The A/THR remains armed and becomes active immediately the thrust levers are returned to the CL detent. Therefore, the thrust levers should be returned to CL detent as soon as there is a positive speed trend. However, there are two important points to note:
‐ Selecting the thrust levers to the TOGA detent, even momentarily, will engage the Go-Around mode,
and. ‐ In some aircraft selecting the thrust levers above the CL detent below 100 ft RA will disconnect the A/THR. In this case, returning the thrust levers to the CL detent will set climb thrust. Refer to FCOM DSC-22_30-90.
Join Date: Apr 2013
Location: everywhere
Posts: 128
Likes: 0
Received 0 Likes
on
0 Posts
Selecting the thrust levers to the TOGA detent, even momentarily, will engage the Go-Around mode,
and. ‐ In some aircraft selecting the thrust levers above the CL detent below 100 ft RA will disconnect the A/THR. In this case, returning the thrust levers to the CL detent will set climb thrust. Refer to FCOM DSC-22_30-90.
and. ‐ In some aircraft selecting the thrust levers above the CL detent below 100 ft RA will disconnect the A/THR. In this case, returning the thrust levers to the CL detent will set climb thrust. Refer to FCOM DSC-22_30-90.
Join Date: Jun 2014
Location: Village of Santo Poco
Posts: 876
Likes: 0
Received 0 Likes
on
0 Posts
Yes it's standard Airbus ops at our mob and we have the largest fleet of A330's in the world ( or at least we did )
I use it unless it's really gusty, then I'd rather do it myself, unlike the mighty 777.
I use it unless it's really gusty, then I'd rather do it myself, unlike the mighty 777.
Join Date: Aug 2013
Location: Middle Europe
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
from FCTM/NO-Normal Operations/NO 110-Approach General/FINAL APPROACH
If the A/THR performance is unsatisfactory, the pilot should disconnect it and control the thrust manually.
Join Date: May 2000
Location: Seattle
Posts: 3,196
Likes: 0
Received 0 Likes
on
0 Posts
on approach with auto thrust on , you find speed going below VAPP or even getting to VLS , what do you do to recover back to your VAPP ?
Join Date: Jun 2000
Location: last time I looked I was still here.
Posts: 4,507
Likes: 0
Received 0 Likes
on
0 Posts
Reading this scares me a little. I am a Boeing pilot and know nothing first hand of the AB families. I also fly small piston a/c. In all my types of a/c over a long career thrust management has always been very simple. Forward = more and backward = less. As Pf you decide what datum to set and adjust around that. A/T might be used on later types, but needed watching and if it was slow to respond then my hand was always rolling through and told the silly billy what to do. never a word of thanks. Watching cadets in TR plug in the automatics and them not monitor them is most amusing, especially if they haven't noticed A/T has gone not ARM. The speed goes off the end or decays in to stick shaker: and I let it. They seem so bewildered that "the computer was engaged and it didn't do its job." A salient lesson learnt and never forgotten.
Back to my point; thrust/speed management was easy and intuitive. Now I read about the AB types that do this or that if you select this detent or that, and if you do this above 100' the a/c will assume this and if you do it below 100' it will assume something else and thus cause a whole chain of events to try and catch you out. Am I being staid in my ways or are they making an easy job difficult? If I first have to think about what else will happen if I push the thrust levers forward or backwards and by how much then it might cause unwanted hesitation, especially if operating different modified thrust systems e.g. A320 & A330 as has been mentioned here. Ouch.
Back to my point; thrust/speed management was easy and intuitive. Now I read about the AB types that do this or that if you select this detent or that, and if you do this above 100' the a/c will assume this and if you do it below 100' it will assume something else and thus cause a whole chain of events to try and catch you out. Am I being staid in my ways or are they making an easy job difficult? If I first have to think about what else will happen if I push the thrust levers forward or backwards and by how much then it might cause unwanted hesitation, especially if operating different modified thrust systems e.g. A320 & A330 as has been mentioned here. Ouch.
Join Date: Jan 2014
Location: UK
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Clearly this is an Airbus specific topic but I have to agree with a few of the other guys. This discussion shocks me to say the least. All my limited experience is of Boeing but come on, can you hear yourselves?
I don't know whether to laugh of cry.
I don't know whether to laugh of cry.
Join Date: Mar 2000
Location: What day is it?
Age: 17
Posts: 71
Received 0 Likes
on
0 Posts
Originally posted by ACMS:
Don't know about the 320 but it's probably similar?
Don't know about the 320 but it's probably similar?
Nice to see those with no AB experience chiming in as usual. Boeing's moving thrust levers are great, and speed tracking does seem better than on the 330/340. However, on AB's non-de-rated types; just pushing fully foward for TOGA thrust and guidance beats Boeing's TOGA button logic/ finger faffing hands down. Not to mention the dubious wisdom of HOLD mode, or having to frequently over-ride the autothrottles on an RNAV STAR in VNAV. A bit like flying with an obstinately poor student. Neither system is perfect and both present opportunities for embarrassment, especially when converting between them.
Join Date: Jun 2006
Location: B.F.E.
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
1. Disconnect all automation.
2. Add power.
3. Put the nose down a little.
4. When speed trend recovers and you start to feel a little "whooop" lift in the seat of your pants, reverse the motion and recover flight path.
5. Land.
If that all seems improbable at the time choose option B.
1. TOGA / GTFOOD (Get The F Out Of Dodge).
Also, the Airbus G/S Mini mode WILL allow speed to decay below Vapp momentarily in very gusty situations. It won't allow it to decay below Vls if all works as advertised. Regularly land in very gusty wind and it does in fact work quite well (A330). Like others have said I do like the feel of manual thrust in those conditions. Hold a stable power setting and let the speed vary a little. Which, come to think of it, is basically what the G/S Mini function is trying to accomplish anyway by giving you a variable speed target.
If the automation doesn't do the job, turn it off. If you work for a company that absolutely forbids this, or you are simply not comfortable doing so, then your choice is simple, go land somewhere else. Bottom line.