2 EO ETP data
Thread Starter
Join Date: Mar 2007
Location: USofA
Posts: 1,235
Likes: 0
Received 0 Likes
on
0 Posts
2 EO ETP data
For those of you who are flying 4 engine equipment (747,340 or 380) are your company flight plans built around a 2 engine out diversion and drift-down scenario, or are you using one engine out data for these ETPs.
Join Date: May 2000
Location: Seattle
Posts: 3,195
Likes: 0
Received 0 Likes
on
0 Posts
YES! An "extended vacation" for 19 hours!
I've flown my 744 for 16+ hours in the past 2 days, so I haven't had time to log in to read or answer your question.
NO 2-engine driftdown data in the flight plans.
I've flown my 744 for 16+ hours in the past 2 days, so I haven't had time to log in to read or answer your question.
NO 2-engine driftdown data in the flight plans.
Join Date: Jul 2011
Location: Inter Nations
Age: 40
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
Flying the 380. We only have one engine driftdowns, that were created for 2 engine aircrafts.
If I lose an engine I might have to descent a couple of thousand feet, but no ETP is needed for these levels.
Losing two engines obviously has a bigger impact. By calculating my max two engine out flight level I can check what escape is needed. In the worst case I use a decompression escape route.
If I lose an engine I might have to descent a couple of thousand feet, but no ETP is needed for these levels.
Losing two engines obviously has a bigger impact. By calculating my max two engine out flight level I can check what escape is needed. In the worst case I use a decompression escape route.
Thread Starter
Join Date: Mar 2007
Location: USofA
Posts: 1,235
Likes: 0
Received 0 Likes
on
0 Posts
Okay thanks. My experience with anything greater than the two engine aircraft has been on the Tri motors and we always used a 2EO ETP. Since losing just one engine on say a 747, does not mandate a diversion and subsequent landing, I expected to see the 2EO ETP's for the Quads as well?
So what I'm hearing here is that all your ETPS are based on a 1EO scenario? I'm familiar with the decompression issues so my interest is limited to the simple loss of one engine, nothing more.
So what I'm hearing here is that all your ETPS are based on a 1EO scenario? I'm familiar with the decompression issues so my interest is limited to the simple loss of one engine, nothing more.
Spooky 2
On a four-engined passenger jet I flew some years ago - fitted with triple INS but no FMCs - our company fuel plans always provided two-engines operating (2EO) data, as well as three-engines operating (3EO) data.
The data provided showed us, if flying on two or three engines, when we would gain (P-IN) or lose (P-NR) a particular airfield, rather than showing an ETP, but an ETP could easily be calculated.
I'm not sure how legible these scans will be, but here is some of the data from a LHR-YYZ flight in late 2003.
This chart shows 3EO data flags above the (random) track and 2EO data flags below the track
This is the same data in numerical form
This data gives the 3EO and 2EO fuel required from various waypoints on track
Best Regards
Bellerophon
On a four-engined passenger jet I flew some years ago - fitted with triple INS but no FMCs - our company fuel plans always provided two-engines operating (2EO) data, as well as three-engines operating (3EO) data.
The data provided showed us, if flying on two or three engines, when we would gain (P-IN) or lose (P-NR) a particular airfield, rather than showing an ETP, but an ETP could easily be calculated.
I'm not sure how legible these scans will be, but here is some of the data from a LHR-YYZ flight in late 2003.
This chart shows 3EO data flags above the (random) track and 2EO data flags below the track
This is the same data in numerical form
This data gives the 3EO and 2EO fuel required from various waypoints on track
Best Regards
Bellerophon
