Go Back  PPRuNe Forums > Ground & Other Ops Forums > ATC Issues
Reload this Page >

Approach speed control in STN

Wikiposts
Search

Notices
ATC Issues A place where pilots may enter the 'lions den' that is Air Traffic Control in complete safety and find out the answers to all those obscure topics which you always wanted to know the answer to but were afraid to ask.

Approach speed control in STN

Thread Tools
 
Search this Thread
 
Old 4th May 2007 | 16:23
  #21 (permalink)  
 
Joined: Nov 2005
Posts: 75
Likes: 0
From: UK
Telstar

I'm a Tower controller at STN. I am unaware of any agreement re 164kts vs 160kts but will look into it if someone hasn't already done so.
The problem with speed not complied with is when we have a large number of inbounds, we will 'pack' to 3nm on final. Any erosion of this spacing is then a loss of seperation, whether it sets alarms of or not. It can also easily lead to go arounds as there may not be suffiecient time for the preceding to vacate.
Equally, there is NO excuse for the app controllers reaction. If they were monitoring you because they had an issue with your speed, they should have done something about it rather than just let it run until you were inside 4 dme.
Anytime you have any problems, feel free to give us a call in the VCR and we'll do our best to resolve it.
Cheers, JBG
jonny B good is offline  
Reply
Old 8th May 2007 | 18:57
  #22 (permalink)  
20 Anniversary
 
Joined: Dec 2000
Posts: 1,543
Likes: 10
From: Samsonite Avenue
Interesting article in CHIRP from a ATCO highlighting poor speed control and possibly alluding to SS since he noted that he has seen 320KIAS on passing BKY!

To those crews who fly into any of the London airports.... just play the game since with Mode S providing IAS data to the guys and girls who are controlling you it is not possible to bull5hit anymore!
Mister Geezer is offline  
Reply
Old 8th May 2007 | 22:22
  #23 (permalink)  

 
Joined: May 2006
Posts: 796
Likes: 0
From: UK
Interesting article in CHIRP from a ATCO highlighting poor speed control and possibly alluding to SS since he noted that he has seen 320KIAS on passing BKY!
It's not uncommon for traffic in to the LHR holds to call approach a few miles from the beacon saying they're doing high speed, having been approved by the TMA, only for approach to say enter the hold delay is x minutes.

It's not always the pilots at fault, depsite the fact TMA and approach have been sitting in the same room for over 10 years now we're not very well joined up at times.
Roffa is offline  
Reply
Old 9th May 2007 | 22:11
  #24 (permalink)  
 
Joined: Feb 2006
Posts: 104
Likes: 0
From: Essex
Jonny, is it only groundspeed you can see? Also do you know what speed the mode S will be reporting? Is it actual speed or selected speed?

And I think you guys do a great job by the way. Sorry for sucking up. And sorry that we don't make enough of an effort listening out on the ground frequency on stand!
I Just Drive is offline  
Reply
Old 9th May 2007 | 22:26
  #25 (permalink)  
Thread Starter
 
Joined: Apr 2005
Posts: 455
Likes: 0
From: Euroville
To those crews who fly into any of the London airports.... just play the game since with Mode S providing IAS data to the guys and girls who are controlling you it is not possible to bull5hit anymore!
Is it selected speed or actual speed readout? With Vertical speed selected you can set the speed at 210 in the MCP but still be doing 300 kts with a V/S of 3000 FPM for example. Not saying I would do this , just saying Mode S might not be foolproof.
Telstar is offline  
Reply
Old 9th May 2007 | 23:51
  #26 (permalink)  
25 Anniversary
 
Joined: Mar 2001
Posts: 1,757
Likes: 0
From: Apa, apo ndi kulikonse!
Ahh but Telstar. We have selected speed as per the Mode S for equipped aircraft, and groundspeed which we have always had. (comes off the radar returns but is fairly accurate (we often ask aircraft for their GS))

We tend to build in wind/descent rates into the thoughts when muttering to ourselves that you haven't slowed down!
AlanM is offline  
Reply
Old 10th May 2007 | 14:13
  #27 (permalink)  
Clone of Victor Meldrew
20 Anniversary
 
Joined: Jan 2004
Posts: 609
Likes: 0
From: england
'I was waiting to see if you were going to slow down'

I have been a Stansted based pilot for many years and have a strong
regard for the professionalism of the all the controllers there.
This includes the Delivery,Ground and Tower who are based in
Stansted control tower and also Director and Essex radar who are
for now still at West Drayton.

However within the last few weeks there is ONE of the radar controllers
who (it seems to me) has an attitude problem.He makes comments which
are quite offensive.

The comment 'I was waiting to see if you were going to slow down' fits
that type of comment.

I would suggest that NATS identify him and provide any required re training.

Kind Regards

390Cruise.
390cruise is offline  
Reply
Old 10th May 2007 | 16:53
  #28 (permalink)  
 
Joined: Jul 2002
Posts: 248
Likes: 0
From: united kingdom
Hello Chaps,
Mode s downlink shows Indicated Airspeed from the ASI, the aircraft heading, the ground speed (if the aircraft is not mode s equipped it will show radar derived ground speed). It will also show the actual rate of climb or descent of the aircarft and the Selected Flight level from the MCP.
Hope this helps.
zkdli is offline  
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.