Circling Calculations
Trying to create a workable spreadsheet for circling calculations.
So far this is what I've come up with. Entries in yellow cells, calculations in blue cells. Comments, questions, and suggestions are welcome. [IMG]http://i779.photobucket.com/albums/y...s52ciyw2d.jpeg[/IMG] |
Why?
... and you're too close to the runway. Should be about 1.5 to 1.7 nm abeam. |
Distance from runway depends on turn-radius for given speed. As speed increases, turn-radius increases, and distance from runnway increases.
Why ? Takes the guesswork out during a procdure that is not commonly flown. |
Hi Dadanawa,
You did bother to draw this circuit out before posting your maths - didn't you? If the downwind heading is 281 degs and the wind is from 269 degs at 10 kts, why are you bothering to circle to land with a 10 kt tailwind on finals? If the circling direction is Left hand circuit (/L) why are you turning Left (253)? You would then surely be turning Right to turn onto finals. (What we used to call a Right Hand Circuit). If I was flying at 1500 ft agl I would fly from abeam THR to base turn for 45 secs in still air. Since I have a 10 kt headwind flying downwind, then I'd turn at 55 secs (not at 33). I think you'll find you need a mental picture to fly circuits - not a list of numbers. |
There is some confusion. I think you mean left break and not circle left? Why 30 degrees offset? should be 45 degrees and 30 seconds.
|
Circling is a visual procedure. More time with eyes outside and less looking at an app might be a step in the right direction.
|
Yes Vilas,
What I mean is a left turn to right downwind. And yes, in this particular case there is a tailwind. (Just entered arbitrary figures) Separate sheet for 45 degree break. I'd say figures can be entered quickly once you get the ATIS. Might take 20 seconds. |
If you can't make this work in your head and translate it into a flight path in the plane, you need to reconsider your career choice. How are you going to use this spreadsheet on a rainy afternoon just below the clouds in a jet?
GF |
At 1500ft do a normal circuit as in most aircrafts done at 2.5 nm downwind displacement. Japs do at 2nm. You don't need a spread sheet.
|
Icao/Pans -ops we fly 4.2nm for 180kts or 5.28 at 205 knots.
|
Reminds me of the situation in my company a while back when the PM noticed PF rummaging in his flight bag when downwind on a visual approach in manual flight with no hands on the controls. When challenged he stated he was looking for his calculator to work out timing from abeam the threshold before turning finals!
|
In the real world, the wind changes as the altitude changes when descending. These changes are sometimes quite significant. I find it works best to look out the window, and vary the bank angle and descent rate as required so the aircraft ends up where I want on short final.
|
The primary instrument in a visual approach is the window.
|
1) Doing a bit of math my help the beginner to understand the limitations and trade space available to when flying the maneuver. The FAA has taken a crack at this for no wind with for us when setting up the A-E category minimums. These have recently been revised as they were a bit optimistic about what could be accomplished safely.
2) As a GA pilot who fly's a bit of IFR into small airport, I have performed as many real (IFR and not training) circle to land as I have real ILS approaches. |
Hill? What hill?
|
B737900er
Icao/Pans -ops we fly 4.2nm for 180kts or 5.28 at 205 knots. |
Vilas
Sorry, I didnt make myself clear there what I meant is those are the limits we fly to. As you said rightly said, you would be well within those limits.
Timing 3seconds per 100' Agl +\- wind |
There is not +\- wind correction for circling approach in according to Airbus documents.
There was the thread here regarding this correction Safe flights |
There is not +\- wind correction for circling approach in according to Airbus documents. |
avoka
There is no such document by airbus. You can read your FCOM the timing is very much there.Also read the thread again fully. |
I am curious to know where in the FCOM or FCTM it states that there is a wind correction for circling . As far as I see there is an "approximate" 3s/100' because it is a visual manoeuvre . That seems to be the only timing mentioned on downwind .
|
Timing 3seconds per 100' Agl +\- wind |
Bloggs: Your 'circling' technique is not that approved by Pans Ops if circling at minima. Yours might work if flying a visual circuit above minima, but not on a manoeuvre conducted with cloud base sniffing minima.
|
Hi Vilas
I did check fcom and fctm during reading that thread and was so surprised that these docs had not recommended to do wind correction.Anyway it's good method to check distanse from active threshold ☝ �� �� and I think it's not so critical to have some extra distance due to tailwind on the base turn! Safe flights |
I am talking about end of down wind time. Blogs, your procedure seems to be different. Airbus wants you to time from abeam threshold as corrected for wind and start a level turn for finals, when you are about 90 degrees to the runway if correctly vertically positioned only then commence final descent. Purpose of timing is to place you at the same spot on ground for final turn. Basically a visual manoeuvre timing is for guidance. It has to be altered as required to remain visual and keep runway in sight.
|
I am talking about end of down wind time. Blogs, your procedure seems to be different. Airbus wants you to time from abeam threshold as corrected for wind and start a level turn for finals, when you are about 90 degrees to the runway if correctly vertically positioned only then commence final descent. Purpose of timing is to place you at the same spot on ground for final turn. Basically a visual manoeuvre timing is for guidance. It has to be altered as required to remain visual and keep runway in sight. And Yes, you do commence final descent only when intercepting the "normal" 3° path. At 500ft, that means a level turn all the way round. |
Vilas
Let's think about the weather conditions during circling.It is not visual maneuver when good vis and clouds so high.It is option for pilot when weather conditions are lower than for visual pattern,but tail wind component little bit greater then wind for straight in approach.On default You have 10 kts min or greater tailwind at point abeam threshold,ergo -1 sec,but I think that it's not so bad to just keep in mind it,but to perform base turn in according to fctm recommendation and You are at point with extra distance from point in calm conditions-You just have to decrease Your v/s , the same time pay more attention to circling radius for cat C,D planes Safe flights |
avoka
When you turn 45 degrees and fly for 30seconds that also needs to be adjusted if winds are strong. That takes care of circling radius. Below from airbus document:(Not for those who consider everything other than what they know as abstract document) 5.4. Timing for Circling: The timing Airbus recommends is 30 seconds from wingslevel, adjusted for strong Head or Tail wind, by reference to the ND windindicator. However, this is a visual exercise: Timings are approximate only. Blogs, I have to disagree with you about going down to 400ft. It is not a question of terrain clearance but obeying the circling minima. You cannot descend below minima to fly level. You can only descend below minima during the final turn |
The timing Airbus recommends is 30 seconds from wingslevel You cannot descend below minima to fly level. |
When you break from the NPA at circling minima and turn 45 degrees either left or right then once the wings are level fly 30 seconds from wings level adjusted for wind for suitable displacement on downwind.
|
Bloggs
Do you operate to TERPS or PANS OPS? PANS OPS says Descent below MDA/H should not be made until: (1). Visual reference has been established and maintained. (2). The pilot has landing threshold in sight. (3). The required obstacle clearance can be maintained and the aircraft is in a position to carry out the landing. Can the last condition be assured on downwind? |
Vilas
agree-RECOMMENDS!!!! just recommended!!! There are not such recommendations in documents,just magazine Safe flights |
Vilas, PANS Ops. As I said, our CAA allows descent below MDA to terrain clearance in daylight prior to final descent.
Still confused about how far Downwind Airbus says. You could turn off the 45° degrees anywhere. But what defines the Base Turn point? 30" from abeam the threshold? |
Bloggs : approximately 45" to the landing threshold .
Vilas : could you say where it states that the downwind timing is adjusted for wind from the abeam point? |
Capn Bloggs is obviously in Australia, where you can descend to 400' obstacle clearance in daytime (but must maintain MDA until you can make a constant descent to land at night).
In Australia it is also typical for the final approach for an NPA to not be runway aligned - it may approach the runway at any angle. Bloggs, the Europeans typically only consider circling from a runway aligned approach - with the circle to the opposite direction runway - so the whole 45º for 30 seconds bit is how they obtain their downwind spacing. Not a good procedure, but Europeans never circle as a rule (so they are always nervous about it), which is why the OP wants an aid for it rather than looking out of the window. |
Stone_cold
There was a instructor seminar held by airbus in 2012 which I myself attended in which one of the topic discussed was circling approach. What I quoted is from that. Since it is a mechanics of approach and a technique I consider it as valid. Otherwise even FCTM has no legal validity like FCOM. Since lateral downwind spacing is determined by ground speed in strong crosswind the head/tail component needs to be catered for. As stated timings are for guidance only. |
Blogs
If you descend to terrain clearance 400ft on downwind do you consider approach stabilised on downwind? What is the stabilised approach requirement for your regulator? |
Vilas : I am not questioning the downwind spacing of 45° / 30 secs. I was asking about +/- corrections to determine the base turn , i.e. timing from the abeam position ( 3 secs/100' ) .
|
Originally Posted by Vilas
If you descend to terrain clearance 400ft on downwind do you consider approach stabilised on downwind?
Back to the OP's issue, while this is supposed to be a purely visual manoeuvre, I think there is a case for using "the system" to help. I'm definitely not suggesting a building a full LNAV/VNAV min wx circuit, but using Fixes makes life easier, with no need for 45/30. My preference is to place a fix at the end of the Downwind leg ie at the Base turn point, then put a "radial" line back along the Downwind leg. When you get Visual, you then simply fly over to the line in TRK, follow it to the fix and turn Base. Having an app that would calculate that Fix point (taking into account spacing out from the runway/crosswind effect and distance/head/tailwind) would be helpful. The stopwatch would be used as a backup. The Fix position would be based on the threshold waypoint. You could input the runway QFU, the wind velocity, the bank on Base and the speed, and it'd spit out the location of the base turn point WRT to landing threshold. For normal circuits, I just use 40° off at 3.4nm. |
Flying circling approach in nav mode is not a good idea and is forbidden in airbus after Air blue crash in Islamabad. Even in India circling approach is forbidden. Why a 3.4nm circuit isn't it too wide?
|
All times are GMT. The time now is 07:35. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.