reverse unlock
Thread Starter
Joined: Jul 2011
Posts: 4
Likes: 0
From: TOULOUSE
On GE Cf680 A300600
Just only in simulator session
If you are in this situation for me you CAN use full reverse
But when you return to iddle and your REV unlock is always present that´s means that your reversé is not stowed
In that way,you havé to shut down the engine
Are you ok with this
Is there a specific call
Just only in simulator session
If you are in this situation for me you CAN use full reverse
But when you return to iddle and your REV unlock is always present that´s means that your reversé is not stowed
In that way,you havé to shut down the engine
Are you ok with this
Is there a specific call
Joined: Apr 2008
Posts: 1
Likes: 2
From: nowhere
Have seen the CF-6 remain in reverse after landing. Only indication was an amber REV light and then upon closer inspection of the vertical tape for N1 showed that it was a bit higher than the other three(I guess it was in approach idle still). Engine was shutdown. After we got outside, only the inner translation cowl was in reverse. The outer side was stowed. Interesting.
What is also interesting is that green indications are normally reasonably good compared to amber indications. But not in flight when it come to an REV indication. Green is really bad.
What is also interesting is that green indications are normally reasonably good compared to amber indications. But not in flight when it come to an REV indication. Green is really bad.
Last edited by JammedStab; 26th August 2013 at 02:57.
Thread Starter
Joined: Jul 2011
Posts: 4
Likes: 0
From: TOULOUSE
Engine shut down
If reverse light stay unlock and REV Green off , i understand that the reverse is not stowed and the best way is to shut down the engine and continue to taxi with one engine inop






