IDG Disconnect
Thread Starter
Joined: Jul 2007
Posts: 5
Likes: 0
From: At home
IDG Disconnect
hi...
i would like to know why the engine must be running and above idle power to diconnect the IDG.
and why the push button should not be held for more than 3 sec's (if my memory servs me right)
thanks
i would like to know why the engine must be running and above idle power to diconnect the IDG.
and why the push button should not be held for more than 3 sec's (if my memory servs me right)
thanks
Joined: May 2005
Posts: 23
Likes: 0
From: AUS
IDG disconnect
A320.(for example )
When engine is not running, the IDG disconnect control signal is inhibited by the engine oil low pressure switch.
This prevents damage to the IDG disconnect mechanism. Mechanism includes:
solenoid, spring loaded disconnect plunger with threaded pawl, worm shaft and ground reset handle.
3 seconds maximum for IDG pushbutton to prevent damage to the disconnect solenoid.
When engine is not running, the IDG disconnect control signal is inhibited by the engine oil low pressure switch.
This prevents damage to the IDG disconnect mechanism. Mechanism includes:
solenoid, spring loaded disconnect plunger with threaded pawl, worm shaft and ground reset handle.
3 seconds maximum for IDG pushbutton to prevent damage to the disconnect solenoid.
Joined: Apr 2004
Posts: 775
Likes: 2
From: near EDDF
Originally Posted by higher320
i would like to know why the engine must be running and above idle power to diconnect the IDG.
completely, this can lead to a clutch damage, such as broken teeth.
Originally Posted by N.E.R.D.
...Mechanism includes:
solenoid, spring loaded disconnect plunger with threaded pawl, worm shaft and ground reset handle.
solenoid, spring loaded disconnect plunger with threaded pawl, worm shaft and ground reset handle.
Joined: Jan 2002
Posts: 960
Likes: 0
From: Brisbane, Australia
Sorry.....Errr.."clutch"....
My understanding, both before and after that great graphic, is that the spring-loaded plunger is released by the solenoid (when the DISC switch is held), and positions itself in the rotating wormdrive of the IDG input shaft.
That rotation then forces the wormdrive to displace the input shaft of the IDG such that the spline is fully withdrawn and all IDG rotation ceases, with (manual) reset only available on the ground with the engine shut down.
If the engine is operating at less than idle RPM, the spline drive may not fully withdraw, and although the IDG will still cease to rotate, the two will not be 100% disconnected, like just enough to damage the spline entry surfaces.
Understand, this is quite a violent mechanical action when actuated, the pin drops in and WHAM, the drive is forced out at great speed, enough to fully separate the two drive ends.
That's about as basic as I can explain it!
Cheers..FD..
My understanding, both before and after that great graphic, is that the spring-loaded plunger is released by the solenoid (when the DISC switch is held), and positions itself in the rotating wormdrive of the IDG input shaft.
That rotation then forces the wormdrive to displace the input shaft of the IDG such that the spline is fully withdrawn and all IDG rotation ceases, with (manual) reset only available on the ground with the engine shut down.
If the engine is operating at less than idle RPM, the spline drive may not fully withdraw, and although the IDG will still cease to rotate, the two will not be 100% disconnected, like just enough to damage the spline entry surfaces.
Understand, this is quite a violent mechanical action when actuated, the pin drops in and WHAM, the drive is forced out at great speed, enough to fully separate the two drive ends.
That's about as basic as I can explain it!
Cheers..FD..
