Gazelle: Flying, operating, buying
Join Date: Dec 2002
Location: Up here, but not for long
Posts: 315
Likes: 0
Received 0 Likes
on
0 Posts
There was a Gazelle lost on Route 5 out of Aldergrove en-route to Lisburn - night, poor Wx, no gogs (early 80's). It was put down to inadvertenet IMC.
I have flown the Gaz with SAS and the very primative stick feel system: SAS was OK but the stick feel - IMO - was crap, we switched it off most of the time.
I have flown the Gaz with SAS and the very primative stick feel system: SAS was OK but the stick feel - IMO - was crap, we switched it off most of the time.
Either way they will make your eyes water when you get the bill. Trying to find an affordable overhaul shop for the components can be a problem too.
Join Date: Jun 2006
Location: Copplestone, Devon
Age: 62
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Gazelle 111a engine
I am involved in a Gazelle restoration and have been given a shopping list !! I am trying to track down a Turbomeca 3a engine for our Gazelle, I am more used to dealing with RR so not to sure of my way around this engine. Any leads at all from anywhere in the world would be gratefully recieved. Contact Chris by reply or [email protected] or 07851 071719. cheers....
Join Date: Mar 2000
Location: UK
Posts: 5,197
Likes: 0
Received 0 Likes
on
0 Posts
MW Helicopters at Stapleford is probably your best starting point.
They maintain most of the UK Gazelle fleet, as well as producing stunning refurbs, .
Martin Woods
Tel: 01708 688115
or email : [email protected]
They maintain most of the UK Gazelle fleet, as well as producing stunning refurbs, .
Martin Woods
Tel: 01708 688115
or email : [email protected]
Join Date: Apr 2002
Location: England
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
Yes.
Unfortunately, the right-angle securing pin for the wheel dolly will fall off if more than 20 degrees angle of bank is exceeded.
Seen it happen. Ground and Aircrew missed it in Yorkshire in the 90s (allegedly).
The pin twatted some mate's garage roof, but luckily he was an on-side chap.
Best one I ever saw was a Wessex in NI when a crew set off for an IF sortie. Pilot stuck his gun (HK53) in a convenient slot in the steps up to the cockpit (barrel nose down) while he checked the rigging.
Set off for an hour's stunting and bunting and had kittens when he trod on his own gat while climbing out of the cab.
Priceless.
Somebody start a thread on lost kit/colliding with fort walls/stolen ammo/ etc
I live in a glass house and will therefore not criticize those who choose to make use of the one metre range.....twice!
To those of you who have done well,.....and you know who you are,...
Well Done!
I jest not.
Unfortunately, the right-angle securing pin for the wheel dolly will fall off if more than 20 degrees angle of bank is exceeded.
Seen it happen. Ground and Aircrew missed it in Yorkshire in the 90s (allegedly).
The pin twatted some mate's garage roof, but luckily he was an on-side chap.
Best one I ever saw was a Wessex in NI when a crew set off for an IF sortie. Pilot stuck his gun (HK53) in a convenient slot in the steps up to the cockpit (barrel nose down) while he checked the rigging.
Set off for an hour's stunting and bunting and had kittens when he trod on his own gat while climbing out of the cab.
Priceless.
Somebody start a thread on lost kit/colliding with fort walls/stolen ammo/ etc
I live in a glass house and will therefore not criticize those who choose to make use of the one metre range.....twice!
To those of you who have done well,.....and you know who you are,...
Well Done!
I jest not.
Join Date: Jan 2001
Location: Home
Posts: 3,399
Likes: 0
Received 0 Likes
on
0 Posts
It will only fall off if you are out of balance Monty!.............you know, the bit of string in front of you that always points to the side.......?
Guess you must be Amateur Air Corps
Guess you must be Amateur Air Corps
Odd, all the diabolo wheels I fitted as groundcrew had a segment cut out to enable the pin to fit behind a locking device, in order to prevent inadvertant extraction.
WRT gats, the decision to withdraw slings from the HK was the result of a floppy driver hanging his on the stores boom while he did the walkround. Said gat eventually dropped off, resulting in a phone call to the feds from a local complaining about the new hole in her garage roof.
WRT gats, the decision to withdraw slings from the HK was the result of a floppy driver hanging his on the stores boom while he did the walkround. Said gat eventually dropped off, resulting in a phone call to the feds from a local complaining about the new hole in her garage roof.
Join Date: Apr 2002
Location: England
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
In balance, gravity wins.
I've seen more amateurs on 72 in the 90's (Pilot Officers/Flying Officers) than I ever saw in the AAC. It was a circus/sinbin for the dross out of Shawbury.
I'm RAF mate, but I know you can't polish a turd.
I've seen more amateurs on 72 in the 90's (Pilot Officers/Flying Officers) than I ever saw in the AAC. It was a circus/sinbin for the dross out of Shawbury.
I'm RAF mate, but I know you can't polish a turd.
Join Date: Apr 2002
Location: England
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
Dig
It wasn't the boom (we're talking Wessex), it was the steps up the side.
Perfect HK53 nozzle slot while you open the transmission deck door to check for....er stowaways.
It wasn't the boom (we're talking Wessex), it was the steps up the side.
Perfect HK53 nozzle slot while you open the transmission deck door to check for....er stowaways.
Join Date: Jun 2003
Location: everywhere the Army sends me
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Should the answer not be; Yes, but why would you want to ???
And i never left my HK anywhere but in the aircraft, but if I did, thanks to the 230 crewman for keeping an eye on it for me!!
And i never left my HK anywhere but in the aircraft, but if I did, thanks to the 230 crewman for keeping an eye on it for me!!
Join Date: Sep 2006
Location: Throwing stones from my glass house
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
I seem to remember someone's HK leaving a nice neat hole on the pan at City Flight in the late 90's too. The cheeky bleeder then tried to hand his weapon (now only good for shooting round corners) back into the armoury at the end of the duty .
Anyway, back to the original question. The Diablo wheels were never meant to flown outside the airframe but I do recall a thin set of wheels which could be stowed on the skid during flight. But why would you want to?
Anyway, back to the original question. The Diablo wheels were never meant to flown outside the airframe but I do recall a thin set of wheels which could be stowed on the skid during flight. But why would you want to?
The rear skid posts have a tube welded to them with a hole for a pip-pin, just for carrying the skinny wheels. You also needed a hydraulic jack plugged into one of the pair of diabolo mounts to raise the cab.
Did the deed once on my Basic Groundcrewman course, and never used them again, apart from lobbing them into the back of the flight G1098 Bedford when we deployed on exercise.
Did the deed once on my Basic Groundcrewman course, and never used them again, apart from lobbing them into the back of the flight G1098 Bedford when we deployed on exercise.
Just for the record the only 'Army' gazelles with SAS
We had SAS fitted to 3 Gazelles in Berlin in the early 80s also it was fitted to both the aircraft we used in Canada in 85 all Army. I had the frightening pleasure of being in the left seat when a colleague tried to go low level over the training area using the SAS but forgot we had a load on an 8ft strop under the aircraft.