tcas alert from a plane without alt ind.
Thread Starter
Join Date: May 2013
Location: EUROPE
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
tcas alert from a plane without alt ind.
Hi,
I have a question if you can help me
What should we do if we have a TCAS traffic alert of a small plane without mode S so no altitude information. What do you do?
personally i avoid the traffic (flying ifr o vfr) and i notify atc.
thank you
I have a question if you can help me
What should we do if we have a TCAS traffic alert of a small plane without mode S so no altitude information. What do you do?
personally i avoid the traffic (flying ifr o vfr) and i notify atc.
thank you
Thread Starter
Join Date: May 2013
Location: EUROPE
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
yes thatīs right, it appears in yellow saying how many miles is from you "2.3 nm" but no altitude indication, so it should be normally below (in other airspace) but i was trying to find somewhere if i should deviate from the horizontal navigation.
between a "mode a" and a "full tcas" equipment there is a TA nothing else of course.
but i am still on doubt of the correct procedure. thanks for your answers
between a "mode a" and a "full tcas" equipment there is a TA nothing else of course.
but i am still on doubt of the correct procedure. thanks for your answers
You get a TA alert on a non altitude reporting target because the system ASSUMES the target is at your altitude and responds by warning you of its presence. The system doesn't KNOW what altitude the target is really at though so it can't give an RA.
If I got one I'd have a look around and put the lights on and hope I don't hit anything. A lot of the time it is caused by low level VFR traffic that are no real conflict and that you will never see.
My FCOM says quite clearly as a warning "DO NOT MANOEUVRE ON A TA ALONE!". If you visually acquire the traffic and it is obviously in conflict, then fine, get out of the way, but to manoeuvre horizontally around a target based on the TCAS display is fraught with danger because the TCAS display does not accurately present bearing information.
If I got one I'd have a look around and put the lights on and hope I don't hit anything. A lot of the time it is caused by low level VFR traffic that are no real conflict and that you will never see.
yes thatīs right, it appears in yellow saying how many miles is from you "2.3 nm" but no altitude indication, so it should be normally below (in other airspace) but i was trying to find somewhere if i should deviate from the horizontal navigation.
Join Date: Feb 2014
Location: Alba
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
I have been retired 10 years, but previous to that when operating in and out of London Heathrow these nuisance warnings were common and infuriating.
They were normally were caused by VFR traffic low down, but it is alarming to get an orange blip and an aural warning that you might be about to hit something.
Traffic with transponders should be forced to have altitude reporting, or be kept out of the airspace.
They were normally were caused by VFR traffic low down, but it is alarming to get an orange blip and an aural warning that you might be about to hit something.
Traffic with transponders should be forced to have altitude reporting, or be kept out of the airspace.
Avoid imitations
Join Date: Nov 2000
Location: Wandering the FIR and cyberspace often at highly unsociable times
Posts: 14,576
Received 425 Likes
on
224 Posts
Traffic with transponders should be forced to have altitude reporting, or be kept out of the airspace.
It is a worry, tbh and all you can do in practical terms (especially when not in receipt of an ATC radar service), is to look out even more.
Thread Starter
Join Date: May 2013
Location: EUROPE
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
it usually happens to me on take off from oxford sometimes on IMC SID and the " hope I don't hit anything" does not calm me. normally i ask for a hdg to avoid the target..never said nothing to me from atc, just report when clear. thanks for answers guys. good landings.
What if the heading you request takes you into the target? If you watch the presentation of targets on a TCAS you will see all sorts of weird stuff, the point being that TCAS bearing information is highly unreliable.
Join Date: Feb 2015
Location: yankton, sd
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
TA no alt?
Fine, start looking, turn on your lights and the traffic is either above you, at the same altitude as you, or below you. Guess where you should look first!
You can ask ATC, DO YOU SHOW TRAFFIC MY 1 o'clock, no altitude?
It is possible ATC is working the traffic and had the altitude reported verbally and advised traffic to report leaving or any altitude changes.
Fine, start looking, turn on your lights and the traffic is either above you, at the same altitude as you, or below you. Guess where you should look first!
You can ask ATC, DO YOU SHOW TRAFFIC MY 1 o'clock, no altitude?
It is possible ATC is working the traffic and had the altitude reported verbally and advised traffic to report leaving or any altitude changes.
By the way, you don't need the conflicting aircraft to have mode S to get an RA, mode A/C will do.
Often happens with Gatwick departures on some SIDs which pass directly over Redhill. If traffic in the Redhill circuit only has mode A you will get a TA.
Often happens with Gatwick departures on some SIDs which pass directly over Redhill. If traffic in the Redhill circuit only has mode A you will get a TA.