Wikiposts
Search
Private Flying LAA/BMAA/BGA/BPA The sheer pleasure of flight.

First solo

Thread Tools
 
Search this Thread
 
Old 10th Nov 2010, 08:58
  #41 (permalink)  
 
Join Date: Jun 2009
Location: On the road...
Age: 49
Posts: 53
Likes: 0
Received 0 Likes on 0 Posts
Read the POH. This should be the basis for everything you do with regard the aircraft. Make sure you are doing the checks specified, you can add more if the school etc requires.
aussiefan is offline  
Old 10th Nov 2010, 09:43
  #42 (permalink)  
 
Join Date: Aug 2009
Location: UK
Age: 42
Posts: 40
Likes: 0
Received 0 Likes on 0 Posts
I'm not sure about what's in the POH, I'll have a look. But in the expanded checklist we use, no.
It just says, check mixture rich --> start engine --> keep micture rich at all times until engine shut down. There are no mixture checks that need to be done.
Paul H is offline  
Old 10th Nov 2010, 09:50
  #43 (permalink)  
 
Join Date: Aug 2009
Location: UK
Age: 42
Posts: 40
Likes: 0
Received 0 Likes on 0 Posts
Ok, thanks stevelup, I'll get the books out again and have a quick read on the carb heat and take your advice on the brakes and controls.
Paul H is offline  
Old 10th Nov 2010, 10:32
  #44 (permalink)  
 
Join Date: May 2001
Posts: 10,815
Likes: 0
Received 0 Likes on 0 Posts
Just have to say I like your attitude Paul.

Personally the not using a checklist is not a crime in my book in a SEP but the the posters have valid views.

The use of mixture is one of the poorly taught items generally in the UK. I must admit I was teaching it incorrectly/didn't know what I was doing. When I was instructing full time. There are some quite good threads if you search for them on the forum.

The carb heat again is taught by alot as something you have a fiddle with as part of a series of checks. Its only after you have a bum twitcher with carb icing you get more switched on with it really does. My bum twitcher was after a PFL on the go-around doing mutal training for my FIC. The 60 seconds it took to clear hanging in the air not accelerating or climbing with the engine farting and shuddering seemed to last a hour.
mad_jock is offline  
Old 10th Nov 2010, 11:59
  #45 (permalink)  
 
Join Date: Dec 2006
Location: Toulouse
Age: 63
Posts: 127
Likes: 0
Received 0 Likes on 0 Posts
flyinkiwi
Yes it can, which is why most lineup checks involve cycling the carb heat.
OK. Something to think about. In all my flying, I have to say that it is not something I've ever done, nor something that's ever been taught to me!

Cheers
VOD80 is offline  
Old 10th Nov 2010, 12:41
  #46 (permalink)  
 
Join Date: Aug 2008
Location: Geneva
Posts: 81
Likes: 0
Received 0 Likes on 0 Posts
It just says, check mixture rich --> start engine --> keep micture rich at all times until engine shut down. There are no mixture checks that need to be done.
Checking the mixture on preflight is paramount. Cruise performance figures are based on the mixture leaned as per the POH (and you may need to lean at takeoff already if your field elevation warrants it). Also one of the memory items in case of engine fire is mixture cutoff. Two very good reasons to make sure it works as advertised before you actually launch
Shorrick Mk2 is offline  
Old 10th Nov 2010, 16:51
  #47 (permalink)  
 
Join Date: Jan 2004
Location: Canada
Age: 63
Posts: 5,209
Received 134 Likes on 61 Posts
Originally Posted by VOD80
A quick question, one that I can't find an answer for with a superficial search. What should you do if you find ice present? Presumably it built up while you were on the ground, could it not build up again before take off?

Cheers!
Put the carb heat on when you are lined up for takeoff. Increase power to runup value to get a good blast of hot air into the carb, pause for 15 seconds or so then if no indications of ice, carb heat off and apply full power. When full power is achieved check that the RPM guage is showing the correct static RPM value (remember this will be well below redline RPM) indicating you are achieving full power, and you are good to go to continue the takeoff.

Adam 1919

I seemed to have hijacked your thread about first solo's, sorry about that.
IMO opinion time to first solo means nothing, what really matters is what your skills and abilities and judgement are as a licensed pilot. The important thing in your flight training is that you are making progress. if you are stuck at any part of the course, including presolo, than you need to have a sit down with your instructor or even the CFI to figure out why you are not progressing and what to do about it.
Big Pistons Forever is offline  
Old 10th Nov 2010, 22:17
  #48 (permalink)  
 
Join Date: Dec 2006
Location: Toulouse
Age: 63
Posts: 127
Likes: 0
Received 0 Likes on 0 Posts
Big Pistons Forever

Put the carb heat on when you are lined up for takeoff. Increase power to runup value to get a good blast of hot air into the carb, pause for 15 seconds or so then if no indications of ice, carb heat off and apply full power. When full power is achieved check that the RPM guage is showing the correct static RPM value (remember this will be well below redline RPM) indicating you are achieving full power, and you are good to go to continue the takeoff.
I like it! Thanks, I'll work that into things from now on.

Cheers
VOD80 is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.