Go Back  PPRuNe Forums > Ground & Other Ops Forums > Engineers & Technicians
Reload this Page >

DC-8-71F Flight Control System


Notices
Engineers & Technicians In this day and age of increased CRM and safety awareness, a forum for the guys and girls who keep our a/c serviceable.

DC-8-71F Flight Control System

Old 4th October 2006 | 23:19
  #1 (permalink)  
Thread Starter
 
Joined: Apr 2002
Posts: 13
Likes: 0
From: Sydney
DC-8-71F Flight Control System

I am currently writing a report on the DC-8 flight control system for university. I have searched google for the answers and numerous books but have come up short on the following questions:

1. I know that the ailerons are power operated, but how is the actuator connected to the cockpit controls, cables, rods, electric?
2. I know that the rudder is also power operated but once again how is it connected to the cockpit controls?
3. How are the flaps connected to cockpit controls?
4. Is everything that is power operated connected to only a single hydraullic system or several?

Any other additional information that may be pertinent is also welcomed. In advance thank you for any replies.

Matt Durbin
durbin is offline  
Reply
Old 5th October 2006 | 15:34
  #2 (permalink)  
 
Joined: May 2004
Posts: 934
Likes: 0
From: Balmullo,Scotland
Originally Posted by durbin
I am currently writing a report on the DC-8 flight control system for university. I have searched google for the answers and numerous books but have come up short on the following questions:
1. I know that the ailerons are power operated, but how is the actuator connected to the cockpit controls, cables, rods, electric?
2. I know that the rudder is also power operated but once again how is it connected to the cockpit controls?
3. How are the flaps connected to cockpit controls?
4. Is everything that is power operated connected to only a single hydraullic system or several?
Any other additional information that may be pertinent is also welcomed. In advance thank you for any replies.
Matt Durbin
1. cables to the actuators-rods via a rather large and thich aileron bus cable also a trim system again operated by cables the ailerons also have a manual reversion so if the hyd pwr drops below 1750 PSI (hope the memory has stayed ok)
2.Again cables to actuator and then cables from actuator to rudder bellcranks.
3.Cables from cockpit controls are attached to the actuators if I remember correctly the hydraulic actuators move a large cable drum in each wheel well which then drives the flaps in the desired direction.
4. Here You come across one of the major design faults of the DC8 it has only 1 Hyd system, when I worked for Southern Air We had an incident where the A/C left the taxiway because of a single hyd pipe burst(no fuse protection on this part either) consequence was the A/C was in a turn and could not straighten itself.
If any SAT Guys read this please add anything I have gotten wrong, particularly. JH,AR,PR,PK(on the A/C when it went on to the grass) and Myself DM
matkat is offline  
Reply
Old 5th October 2006 | 21:16
  #3 (permalink)  
 
Joined: Jun 2003
Posts: 497
Likes: 0
From: Near LOACH intersection
vanished post?
ferrydude is offline  
Reply
Old 5th October 2006 | 21:28
  #4 (permalink)  
Thread Starter
 
Joined: Apr 2002
Posts: 13
Likes: 0
From: Sydney
No, no vanished posts. I just placed my question in a couple of different forums to get different answers and to speed up the replies. By the way thanks for your's.

Durbin
durbin is offline  
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.