MS Works 8 Word processor problem
Thread Starter
Join Date: May 2003
Location: South East England
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
MS Works 8 Word processor problem
Whenever I try to copy and paste into a Word Processor doc, I get this message:
" The information you have copied exceeds the limit for pasting into the Word Processor. Try reducing the size of your selection, and then copy and paste again".
Even reducing the selection to a few words generates the same response.
When carrying out the same process in Open Office it works perfectly.
I've tried re-installing Works and doing a search for the problem but to no avail.
Any suggestions, Gentlemen?
Thank you,
N o t a
PS I've looked at the clipboard contents and only the text I had copied was present, ie: it wasn't overloaded.
" The information you have copied exceeds the limit for pasting into the Word Processor. Try reducing the size of your selection, and then copy and paste again".
Even reducing the selection to a few words generates the same response.
When carrying out the same process in Open Office it works perfectly.
I've tried re-installing Works and doing a search for the problem but to no avail.
Any suggestions, Gentlemen?
Thank you,
N o t a
PS I've looked at the clipboard contents and only the text I had copied was present, ie: it wasn't overloaded.
Spoon PPRuNerist & Mad Inistrator
Thread Starter
Join Date: May 2003
Location: South East England
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
Aha! As Alan partridge might say...............
Thanks for that SD. I wasn't too hopeful that that one was going to succeed as it apparently only applies to Works 6 & 7 but it's a perfect solution.
I'm going to apply the engineering adage of 'working well, leave it alone'.
Thanks again,
N o t a
Thanks for that SD. I wasn't too hopeful that that one was going to succeed as it apparently only applies to Works 6 & 7 but it's a perfect solution.
I'm going to apply the engineering adage of 'working well, leave it alone'.
Thanks again,
N o t a