Airbus Flysmart Landing Module

[The Old Swedish]

Hi,

would appreciate if some one would be so kind and aswer me the following:

Why does the AIB Landing calculates an OEI MISSED APPROACH GRADIENT from 800ft (plus elevation at treshhold)?

Thank you,

TOS

[Denti]

Must be a company preset. In my outfit it uses 1000ft AGL as standard. However, you can change that simple enough, simply click on the runway and you get a box where you can modify at which altitude the GA gradient should be calculated.

[compressor stall]

According to the Flysmart Setup documentation (from 2 years ago),

"As per regulation, the GA gradient that must be checked against the minimum regulatory values is determined at the runway elevation."

Your Flysmart admin can enable a setting to measure the GA gradient at a higher elevation, which is referred to by Denti - but only between 1500' and 10,000'.