planecrazy.eu
21st Nov 2007, 14:01
Hey All
Not sure if anyone here would know how to do this, but i think there is as good chance as asking any other place.
I need to simulate a diode circuit in MultiSim or any sim package that has a 100OHM resistor in the circuit. I need to set an input voltage and then see the current after the diode.
I am trying to reproduce a diode curve in a simulation environment and so far have just got linier results rather than a nice curve.
Any help?
Could post an image of what i am trying to achieve if any help?
Not sure if anyone here would know how to do this, but i think there is as good chance as asking any other place.
I need to simulate a diode circuit in MultiSim or any sim package that has a 100OHM resistor in the circuit. I need to set an input voltage and then see the current after the diode.
I am trying to reproduce a diode curve in a simulation environment and so far have just got linier results rather than a nice curve.
Any help?
Could post an image of what i am trying to achieve if any help?