Originally Posted by
canyonblue737
Yes, clearly different than a runway and yes, the column cutout doesn't work with MCAS. Yes the trim wheel moving, even in manual flight, even when not trimming with the yoke switch is normal in a 737. That said you would think in 7-12 minutes of watching the nose get heavier and heavier and the trim moving downward on occasion on its own you would kill the trim with the stab cutout switches. I totally get the anger at Boeing but experienced 737 pilots should be able to figure this out, in particular with a bit of time, and after the Lion Air accident and the required reading of the MCAS system and its failure mode you would think any 737 MAX pilot would be able to figure this out very, very quickly let alone with time. Lots of blame to go around here in these accidents, starts with Boeing but as usual it ends in the point end of the jet.
”Pilot” v “Operator” perhaps?