"Radio Altimeter Alive" call
Can any 320 operators tell me, when you hear "Twenty Five Hundred" what is your call response and why |
No response. |
“Checked” by both PF & PM according to our SOPM. Reasons: To confirm it’s correctly displayed on both PFDs and for awareness I guess. |
More talking the plane to death then forgetting to fly just like Captain Bob said :} |
PA.. sounded like that was said with feeling:) Anyhow this could be fun ....any of the BA Airbus folks care to give the company specific answer? Actually they probably started typing chapter and verse a few hours ago but haven’t finished the reply yet...;) |
Any call auto or by respective crew member has to be acknowledged otherwise there's no way of knowing whether it was herd. Also it guards against possibility of crew incapacitation. Some response as "checked" is appropriate.
|
But I like their callouts https://m.youtube.com/watch?v=yQyGdY31gos
Wiggy, Bob used to have me hysterical laughing RIP 411A |
Any call?
"ONE HUNDRED" - Checked! "FIFTY" - Checked! "FORTY" - Checked! "THIRTY" - Checked! "TWENTY" - Checked! "TEN" - Checked! Surely not... |
By FCOM, it’s a standard callout for the PF to call “checked” when the RA is alive. I’m not a big fan of “too many call outs” in the cockpit but this one it’s quite important especially if you are doing LVO. |
BA - we call “position check” and the PM responds with the procedure, distance, altitude and baro ref. Part of the approach brief should include where you expect the RA to go off so it shouldn’t be a surprise when it does. Champ |
Definitely a good reason Pineteam
|
Originally Posted by champair79
(Post 10134198)
BA - we call “position check” and the PM responds with the procedure, distance, altitude and baro ref. Part of the approach brief should include where you expect the RA to go off so it shouldn’t be a surprise when it does. Champ :ouch: |
LOL. And I thought we had too many callouts.. xD |
The BA SOP might be 'over the top' in that it is spoken out loud. However, it is quite obvious from flying with numerous cadets in another airline, that when the RA chirped up at 2500' their response had no SA awareness whatsoever. I used to encourage them checking it against baro and confirming to themselves it made sense. It was not taught/mentioned as an airmanship SOP; the response was a piece of parrot mouth music to satisfy SOP's. Going into AGP RW14 and cutting the corner to the LOC it was not unusual to have the RA alive at 30nm from touchdown. Descending IMC that needs some understanding, good SA and confident awareness of where you are. However, there did not seem any curiosity that this triggered so far from the runway; just the parrot response. I'm sure there are many more airports where you are descending on procedures below MSA & IMC where the RA will be triggered early.
|
In the 737-200 when the RA came alive it triggered a an amber warning light directly in front of the captain. In those days we wound up the RA selector to full scale (2500 ft) during the cruise check and left it there.
Descending into Guadalcanal (Solomon Islands South Pacific) at night we would receive a momentary alert from the RA light and the numbers would flash down for a second or two as we passed over the top of a 7000 ft mountain 15 miles from Henderson Field of WW2 fame. Thus it was a poor man's GPWS and excellent situational awareness. |
Just "Rad Alt alive"
|
Originally Posted by TangoAlphad
(Post 10134332)
On short UK domestic hops do BA need to start briefing at 'gear up.. now plate 10-2C...' :}
I’ve heard the “position check” call is being changed in the not too distant future but I don’t have any information on what it might change to. Whilst many ridicule BA, the SOP is in place for precisely the reason RAT5 mentioned. It’s a final check to make sure both crew members are happy with where the aircraft is and it gives time to correct the flight path if an error is found. For most ILS’s, it’s also a good point to check that the glideslope looks sensible and you haven’t false-captured it. Champ |
Champair79 - never had the short, normal and long briefs for home base? Short - “Heathrow” Normal - “Standard Heathrow” Long - “Standard Heathrow 27L” |
Re approach brief, Isn’t the clue in the name? |
Originally Posted by Jwscud
(Post 10134551)
Champair79 - never had the short, normal and long briefs for home base? Short - “Heathrow” Normal - “Standard Heathrow” Long - “Standard Heathrow 27L” |
I guess because ive been flying for so long, I just assume all pilots would know the history behind the need for SOMETHING to be said (and why) upon the radio altimeter coming alive.This is variously responded to with a call such as "terrain" "radio altimeter alive" or "twenty five hundred" or even "check" but not "checked".The reason for this is as always, situational awareness.Are you expecting terrain as this point? If not then this may be an early warning of something bad about to happen.It seems that this type of call became common place after the Air New Zealand DC10 accident, where no action was taken by the crew upon noticing the RA coming alive.Also the accident itself if I recall correctly was the reason why the GPWS response became what it is today.It is possible, just, that if that crew used todays GPWS response the accident may have been averted thus saving nearly 300 lives.
Many times in the SIM when I notice crews ignoring the RA alive call I later give them a hard GPWS out of nowhere and many many times they have crashed.Lesson learnt hopefully. |
Not looking at the actual radio displacements and height:\
|
Interesting subject
OK I have a related question, Whatever the callout is do we have to say it right when the aircraft announces "2500" or when it actually starts to show the reading? because often there is a few seconds gap there. |
Talking for Airbus, I never noticed such a delay. In any case, the call out by the crew should be made when the reading is displayed. in the other hand, I noticed sometimes the RA comes alive but no auto call out at 2500 AGL. Don’t know why. |
SOPs aside; It is good airmanship to acknowledge the 2,500’ RA autocall, then look at your own RA display and then the other side RA display. You want to be sure both Rad Alts are working; that they are sensible and reasonable and have ‘woken up’ about where you would expect them to - you are approaching the ground, after all* You want to make sure both Rad Alts are giving the same measurement - odd things might happen with a Rad Alt disagree that could compromise your approach. It is a good point at which to check the other pilot is still OK and has not passed out or anything, during or before your approach. * ”poor man’s GPWS” - well said. :ok: |
Now what's the bet that each airlines call out mentioned here claims they're doing "airbus procedures"
|
The reason BA have put so much mouth music into this is because it is your last chance to trap the threat of flying a beautiful 3 degree non precision descent into the undershoot with the wrong qnh set. EGPWS will not save you for a 10hPa error. Agree it can be overkill on a glide path, but is still useful for SA. Most CFIT occurrences I read about seem to involve crews that thought they were in the slot. I quite like the 'if we get it beyond 9Dme or above 3000 ft, we've made a mistake, or we're not where we thought we would be" approach. |
Originally Posted by pineteam
(Post 10134921)
Talking for Airbus, I never noticed such a delay. In any case, the call out by the crew should be made when the reading is displayed. in the other hand, I noticed sometimes the RA comes alive but no auto call out at 2500 AGL. Don’t know why. So true about the No auto callout, I'd like to know the reason too |
Originally Posted by RAT 5
(Post 10134253)
The BA SOP might be 'over the top' in that it is spoken out loud. However, it is quite obvious from flying with numerous cadets in another airline, that when the RA chirped up at 2500' their response had no SA awareness whatsoever. I used to encourage them checking it against baro and confirming to themselves it made sense. It was not taught/mentioned as an airmanship SOP; the response was a piece of parrot mouth music to satisfy SOP's. Going into AGP RW14 and cutting the corner to the LOC it was not unusual to have the RA alive at 30nm from touchdown. Descending IMC that needs some understanding, good SA and confident awareness of where you are. However, there did not seem any curiosity that this triggered so far from the runway; just the parrot response. I'm sure there are many more airports where you are descending on procedures below MSA & IMC where the RA will be triggered early.
IMO, any call that does not require a thoughtful response from the other pilot is no more than occupational therapy for the caller. Good CRM demands mutual understanding and cross-checking. One crew member must not spoon-feed or sucker the other into adopting his/her mistake or misunderstanding. Calls should also assist each pilot to identify subtle incapacitation or overload in the other. However, calls must not be allowed themselves to exacerbate overload. |
AF makes the call checked the twenty-five hundred call, at least so it seems...
https://m.youtube.com/watch?t=97s&v=F7D33_u9DE0 |
Originally Posted by Pugilistic Animus
(Post 10135411)
AF makes the call checked the twenty-five hundred call, at least so it seems...
https://m.youtube.com/watch?t=97s&v=F7D33_u9DE0 |
Vessbot it is illegal not to call checked less than 10 times in any large transport category airplane...:}
|
Just watched the whole video that didn't seem like That many callouts, really :)
|
Way back when Airbus still made jets with wire connecting the yoke (What is That) to the control surface and me sitting between two great aviators, the second officer called out 50, 40, down to touchdown. I'd often call "five, ten, five, four, eight, nice one number one!"
Maybe may be we should be more serious...... |
Its not such a silly idea.Many times ive seen in the SIM with certain failures that fail the radio altimeter, many pilots have quite a hard time timing the flare, and getting the PM to call out the heights near the ground helps a lot.On the other hand on some types not fitted with auto callouts, Captains have asked for the calls from me in poor visibility, greatly enhancing their ability to make a safe landing.Good airmanship.
|
Having had a GPWS failure in a 773 a few months back, I just asked my partner in crime to call “50” and flared based on the view out of the window. Result (in benign conditions) - my best landing of the year. The main thing I missed was not so much the call outs but the cadence of the call outs giving an extra cue to the rate of descent and progress of the flare. |
Originally Posted by piratepete
(Post 10134669)
This is variously responded to with a call such as "terrain" "radio altimeter alive" or "twenty five hundred" or even "check" but not "checked".The reason for this is as always, situational awareness.Are you expecting terrain as this point? If not then this may be an early warning of something bad about to happen.
The standard callout is entirley dependant on YOUR company Standard Callouts. Its at the back of the SOP section in your FCOM, for those who have never seen it. |
IBE thats an interesting situation indeed.That is a good example of using an appropriate call to bring attention to the terrain.The part of the Boeing/Airbus FCOM (or FCTM) that lists recommended standard callouts is well known by most pilots, however , as is always the case, these aircraft are under the control of the operator and as the postholders (DFO Chief Pilot Training Manager) have the final say with respect to what goes in the OM(A and B), this opens the door to many many different ways of presenting this part of SOPs to the crews.I know this well as I have been a postholder several times and must admit that the first time I had this responsibility I went overboard with standard callouts.Over time I have toned this down and now, if I had to do it again would use the manufacturers calls with minimal changes.However there are a few variations that are just too important from a safety perspective to not use, and the call after the radio altimeter comes alive is one of them.Around the world there are countless versions of standard calls in use some of them quite bizarre, but this is done because IT CAN BE DONE......
A question for you.Can you explain the reason for one manufacturers call at DA "continue"? Why not " landing or land" What is the purpose of this call and when should it be used?.....Peter. |
"Continue" seems more accurate to me, because that's what you're doing. But you don't know yet if you're landing.
|
The call "Landing" was changed by airbus to "continue" because it became like a commitment to land and the only decision you take at minima is go around flaps or continue. Even below minima GA possibility exists. This is subtle change some airlines still use landing.
|
All times are GMT. The time now is 11:01. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.