737 Lav Flush/Cabin Diff
Thread Starter
Joined: Dec 2001
Posts: 428
Likes: 8
From: Middle East
737 Lav Flush/Cabin Diff
I've been whiling away another boring lockdown day by watching one of the excellent Pilots Eye videos, this one following a crew in an Air Berlin (ah the memories) B737-800 from Munich to Hurghada. They were discussing pax moving about the cabin and the resulting effect on trim as they get up and down to use the lav, the joke being 'the worse the food, the more the trim'. Who says Germans don't have a sense of humour? 
They also pointed to the cabin diff gauge on the overhead and showed the needle climbing up a little before returning to normal, saying that when the lav was flushed that cabin air was vented overboard. I didn't quite understand this, but this was with English subtitles of German dialogue so maybe something was lost in translation. I know that the 737 uses a vacuum lav, but how is that connected with the outflow valve? Is the air that gets sucked into the vacuum lav vented overboard? I've never heard of this one before, so was curious.
Thanks in advance. RU
They also pointed to the cabin diff gauge on the overhead and showed the needle climbing up a little before returning to normal, saying that when the lav was flushed that cabin air was vented overboard. I didn't quite understand this, but this was with English subtitles of German dialogue so maybe something was lost in translation. I know that the 737 uses a vacuum lav, but how is that connected with the outflow valve? Is the air that gets sucked into the vacuum lav vented overboard? I've never heard of this one before, so was curious.
Thanks in advance. RU
Joined: Sep 2016
Posts: 90
Likes: 0
From: Amongst the Gum Tree's
without consulting the books, the basic principle is to :
1. use diff press above 16000ft to 'push', or 'blow', the poo from the bowl down to the waste tank, then separate the poo (waste) at the tank, and discharge the stinky air overboard via an orifice we called 'the poo chute', typically on the left hand side at the back - the orifice with brown streaks coming from it (insert spewing face here)
2. use the 'blower' to create a vacuum below 16000ft to 'suck' the waste down to the tank, then separate the poo (waste) at the tank, and discharge the stinky air overboard via an orifice we called 'the poo chute', typically on the left hand side at the back - the orifice with brown streaks coming from it (insert spewing face here)
The outflow valve has nothing directly to do with water/waste management.
The pressure sensor for the ovhd pnl cab diff press is, from memory and dont quote me, on the back of the gauge itself. If not, its in the equip centre somewhere.
It is possible that the cab diff press sensor can sense the subtle cabin pressure change due to toilet flush (an induced pressure leak). I would have thought, that the flush would cause the needle to dip to a lower pressure momentarily, however, there might be a phenomena/characteristic that im forgetting that causes a sudden rise in pressure when the flush valve changes state from closed to open.
hope this helps... i dont like to make over complicated explanations
1. use diff press above 16000ft to 'push', or 'blow', the poo from the bowl down to the waste tank, then separate the poo (waste) at the tank, and discharge the stinky air overboard via an orifice we called 'the poo chute', typically on the left hand side at the back - the orifice with brown streaks coming from it (insert spewing face here)
2. use the 'blower' to create a vacuum below 16000ft to 'suck' the waste down to the tank, then separate the poo (waste) at the tank, and discharge the stinky air overboard via an orifice we called 'the poo chute', typically on the left hand side at the back - the orifice with brown streaks coming from it (insert spewing face here)
The outflow valve has nothing directly to do with water/waste management.
The pressure sensor for the ovhd pnl cab diff press is, from memory and dont quote me, on the back of the gauge itself. If not, its in the equip centre somewhere.
It is possible that the cab diff press sensor can sense the subtle cabin pressure change due to toilet flush (an induced pressure leak). I would have thought, that the flush would cause the needle to dip to a lower pressure momentarily, however, there might be a phenomena/characteristic that im forgetting that causes a sudden rise in pressure when the flush valve changes state from closed to open.
hope this helps... i dont like to make over complicated explanations
Joined: Nov 1999
Aviation Qualifications: ATPL
Posts: 3,150
Likes: 744
From: UK
Regarding pax moving about affecting the trim; my first commercial flying job was on the Shorts 360; the "Shed". No autopilot, hand flown all the time. One could feel the change in pitch as our cabin crew walked from the galley at the back to the cockpit - requiring slight extra back pressure on the yoke to stay level. If I was flying I could say to the Captain, "Our coffee is coming". "Eh?" they would say, before the cockpit door slid open and our hostie would be there; " hello boys, here's your coffee".
Thread Starter
Joined: Dec 2001
Posts: 428
Likes: 8
From: Middle East
Regarding pax moving about affecting the trim; my first commercial flying job was on the Shorts 360; the "Shed". No autopilot, hand flown all the time. One could feel the change in pitch as our cabin crew walked from the galley at the back to the cockpit - requiring slight extra back pressure on the yoke to stay level. If I was flying I could say to the Captain, "Our coffee is coming". "Eh?" they would say, before the cockpit door slid open and our hostie would be there; " hello boys, here's your coffee".
Joined: Nov 1999
Aviation Qualifications: ATPL
Posts: 3,150
Likes: 744
From: UK
Not the ones we flew, hence we could feel the coffee approaching the cockpit
No flight directors either, it was all hand flown, properly trimmed and relying on your instrument scan. Great for consolidation of basic flying skills.
No flight directors either, it was all hand flown, properly trimmed and relying on your instrument scan. Great for consolidation of basic flying skills.
Joined: Jan 2008
Posts: 17,738
Likes: 2,119
From: Reading, UK
IIRC, later examples had F/D, but still no A/P.
Thread Starter
Joined: Dec 2001
Posts: 428
Likes: 8
From: Middle East
Gotcha. I worked with a lass years ago who was cabin crew on Sheds and she said the big boxy fuselage made it a nice spacious aircraft to work in. She went onto the EMB 145 sometime after, which it appears was quite the opposite!
Joined: Jan 2013
Posts: 263
Likes: 0
From: Seattle Area
It is possible that the cab diff press sensor can sense the subtle cabin pressure change due to toilet flush (an induced pressure leak). I would have thought, that the flush would cause the needle to dip to a lower pressure momentarily, however, there might be a phenomena/characteristic that im forgetting that causes a sudden rise in pressure when the flush valve changes state from closed to open.
