RAIM
Thread Starter
Join Date: Jul 2012
Location: korea
Age: 48
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
RAIM
RAIM outage predicted for NPA as flw
- what is exact meaning of this
-why RAIM expected at this time of day for NPA not DEPARTURE SID?
RAIM is only apply to NPA?
- what is exact meaning of this
-why RAIM expected at this time of day for NPA not DEPARTURE SID?
RAIM is only apply to NPA?
Join Date: Jul 2007
Location: Germany
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
All to do with RNP vs RNAV performanced based requirements.
NPA = RNP requirement (containment) for example, RNP0.3, or RNP 0.15(AR)
SID typically RNAV1
Comes down to definitions.
Also, depends on your certification standard:
Taken from:
https://www.icao.int/SAM/eDocuments/...NAV2%20eng.pdf
NPA = RNP requirement (containment) for example, RNP0.3, or RNP 0.15(AR)
SID typically RNAV1
Comes down to definitions.
Required Navigation Performance (RNP) Specification. Area navigation specification that includes the performance control and alerting requirement, designated by the prefix RNP; e.g., RNP 4, RNP APCH, RNP AR APCH.
Area Navigation (RNAV) Specification.- Area navigation specification that does not include the performance control and alerting requirement, designated by the prefix RNAV; e.g., RNAV 5, RNAV 2, RNAV 1.
Area Navigation (RNAV) Specification.- Area navigation specification that does not include the performance control and alerting requirement, designated by the prefix RNAV; e.g., RNAV 5, RNAV 2, RNAV 1.
5) If only TSO-C129 equipment is used to meet RNAV 1 and RNAV 2 requirements, it is necessary to confirm RAIM availability for the flight route (route and time) foreseen, using current GNSS satellite information.
6) If only TSO-C145/C146 equipment is used to meet RNAV requirements, the pilot/operator does not need to make any prediction if it is confirmed that the wide area augmentation system (WAAS) coverage is available along the entire flight route.
6) If only TSO-C145/C146 equipment is used to meet RNAV requirements, the pilot/operator does not need to make any prediction if it is confirmed that the wide area augmentation system (WAAS) coverage is available along the entire flight route.
https://www.icao.int/SAM/eDocuments/...NAV2%20eng.pdf
Join Date: Aug 2002
Location: Up north
Posts: 1,657
Likes: 0
Received 0 Likes
on
0 Posts
why RAIM expected at this time of day for NPA not DEPARTURE SID?
CP
Join Date: Jul 2007
Location: Germany
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Some technical standards require GPS lock prior to commencing the takeoff run. It depends upon the aircraft. I believe the INS Lat/Long on the 73 are confirmed at the threshold by engaging TOGA (not my type so dont shoot me down pls...)
Join Date: Sep 2011
Location: FL390
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
Pragmatically speaking, you need two things to fly GPS approaches to LPV minimums... GPS (obviously) and the ability to detect if that signal is degraded or inaccurate.
That's where RAIM comes in. It doesn't make the approach any more accurate, but it does allow you to check the validity of your calculated position.
You can calculate a good fix from six or nine SVs, but you need 24(23?) for RAIM to work. You can calculate in advance whether you'll have that many, which is why you have a note to that effect.
Honeywell FMS on the Airbus can do the calculation for you. I've never seen it come up with a negative answer, but you'd expect good coverage at middle latitudes in the northern hemisphere.
That's where RAIM comes in. It doesn't make the approach any more accurate, but it does allow you to check the validity of your calculated position.
You can calculate a good fix from six or nine SVs, but you need 24(23?) for RAIM to work. You can calculate in advance whether you'll have that many, which is why you have a note to that effect.
Honeywell FMS on the Airbus can do the calculation for you. I've never seen it come up with a negative answer, but you'd expect good coverage at middle latitudes in the northern hemisphere.
Join Date: Aug 2013
Location: PA
Age: 59
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
With many RNP procedures, especially RNP-AR, part of the preflight is the RAIM Prediction Report. If dispatch or crew determines there is not sufficient GPS coverage, the procedure cannot be used. Currently your typical RAIM report is NPA (arrival and alternate airports), and route. If the SID is RNAV, a RAIM check is required.
AUGUR RAIM Prediction
https://sapt.faa.gov/raim-summaries....Type=129001450
Many of the mountainous routes in China, the only procedures are RNP AR, so the RAIM check is imperative for both RNP AR departure and RNP AR approach.
Here is what you need for RAIM, minimum of 5 sats for fault detection, 6 sats for fault detection and exclusion. The HPL is also a consideration.
The FMS is always calculating RAIM, and enroute always governs over prediction, so this can have quite the effect on the flight.
AUGUR RAIM Prediction
https://sapt.faa.gov/raim-summaries....Type=129001450
Many of the mountainous routes in China, the only procedures are RNP AR, so the RAIM check is imperative for both RNP AR departure and RNP AR approach.
Here is what you need for RAIM, minimum of 5 sats for fault detection, 6 sats for fault detection and exclusion. The HPL is also a consideration.
The FMS is always calculating RAIM, and enroute always governs over prediction, so this can have quite the effect on the flight.
Last edited by underfire; 21st Jun 2018 at 17:21.
Join Date: Aug 2013
Location: PA
Age: 59
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Example Current Prediction http://www.nstb.tc.faa.gov/24Hr_WaasRNP3.htm
Join Date: Jul 2014
Location: Germany
Posts: 344
Likes: 0
Received 0 Likes
on
0 Posts
[....]
Here is what you need for RAIM, minimum of 5 sats for fault detection, 6 sats for fault detection and exclusion. The HPL is also a consideration.
The FMS is always calculating RAIM, and enroute always governs over prediction, so this can have quite the effect on the flight.
Here is what you need for RAIM, minimum of 5 sats for fault detection, 6 sats for fault detection and exclusion. The HPL is also a consideration.
The FMS is always calculating RAIM, and enroute always governs over prediction, so this can have quite the effect on the flight.
Join Date: Aug 2013
Location: PA
Age: 59
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
With WAAS, you do not need a RAIM check for LNAV/VNAV approach, LPV approach. AFAIK, you still have to RAIM check for RNAV RNP. The HPL/VPL need to be checked.
RAIM checks are no longer required unless you lose WAAS coverage. With WAAS, the receiver can now be used for primary navigation. But these receivers, certified under TSO C146, must still check for integrity of your GPS position solution, and this check is more sophisticated since there are new integrity requirements for approaches with vertical guidance that are more stringent than for LNAV approaches.
RAIM checks are no longer required unless you lose WAAS coverage. With WAAS, the receiver can now be used for primary navigation. But these receivers, certified under TSO C146, must still check for integrity of your GPS position solution, and this check is more sophisticated since there are new integrity requirements for approaches with vertical guidance that are more stringent than for LNAV approaches.