What to do when the throttle is stuck
Thread Starter
Joined: Apr 2008
Posts: 1
Likes: 2
From: nowhere
What to do when the throttle is stuck
a Boeing 757-200 aircraft , was conducting flight 7070 from point A to Point B. During cruise at FL390, the flight crew selected speed intervene and manually selected a lower speed due to light to moderate turbulence. The right thrust lever retarded normally, however the left one did not move. The auto throttle system was disconnected and the first officer tried to move the left thrust lever manually, without success. The flight crew referenced the QRH for a jammed thrust lever; however there is no listed procedure. A PAN PAN was declared at this point.
During the descent through FL230, the flight crew noticed that the TAT was 3° Celsius and attempted to move the left thrust lever, which worked normally with manual manipulation. The auto throttle system was re-engaged and worked normally. The aircraft landed safely with
ARFF on standby.
The operator’s maintenance inspected the aircraft and returned the aircraft to service under MEL 22-30-01-01 (Auto Throttle System).
Wait for it to thaw.
During the descent through FL230, the flight crew noticed that the TAT was 3° Celsius and attempted to move the left thrust lever, which worked normally with manual manipulation. The auto throttle system was re-engaged and worked normally. The aircraft landed safely with
ARFF on standby.
The operator’s maintenance inspected the aircraft and returned the aircraft to service under MEL 22-30-01-01 (Auto Throttle System).
Wait for it to thaw.
Joined: Feb 2017
Posts: 1,013
Likes: 15
From: Isla Grande
Tarom 371....
https://en.wikipedia.org/wiki/TAROM_Flight_371
https://en.wikipedia.org/wiki/TAROM_Flight_371
Joined: Mar 2002
Posts: 4,569
Likes: 1
From: Florida
The Tarom incident was preceded the year before by a similar crash of a B737-300 in China which had not yet released a summary report.
The industry strengthened its reaction to such failures in recommended pilot recognition and response training.
Seems like this crew handled it well.
The industry strengthened its reaction to such failures in recommended pilot recognition and response training.
Seems like this crew handled it well.
its£5perworddammit
Joined: Nov 2003
Posts: 148
Likes: 0
From: the foxhole
Joined: Dec 1998
Posts: 3,038
Likes: 52
From: .
Joined: Jun 2000
Posts: 4,507
Likes: 4
From: last time I looked I was still here.
This scenario started at FL390 and lasted until FL230 after much head scratching, I'd expect. The CVR would be very interesting in a training sense.
I TL at idle 1 TL at crz. How did they descend? Ever decreasing circles? Side slip?
How did they expect to make an approach in a controlled manner? Did they consider shutting down the engine? An over speeding engine requires a shut down. Fortunately this fault cured it self, but what if..........
'ground test, found satis' seems a bit glib. Why should it not happen again? or were they restricting the a/c to FL230?
There is more to this, and much to learn; both pilots and engineering: from what has been reported by the thread starter.
I TL at idle 1 TL at crz. How did they descend? Ever decreasing circles? Side slip?
How did they expect to make an approach in a controlled manner? Did they consider shutting down the engine? An over speeding engine requires a shut down. Fortunately this fault cured it self, but what if..........
'ground test, found satis' seems a bit glib. Why should it not happen again? or were they restricting the a/c to FL230?
There is more to this, and much to learn; both pilots and engineering: from what has been reported by the thread starter.
Joined: Nov 2004
Posts: 51
Likes: 1
From: London
I had a similar experience on a 747 Classic some years ago.
Following heavy rain during the ground turnaround the subsequent departure and climb to cruise appeared normal, however upon making a step climb to FL370 we discovered the No3 T/Lever was immovable. We were able to accomplish the climb without difficulty and at the new cruise level the FCU provided substantially normal cruise thrust.
Suspecting ice build up had affected the T/lever control run, the TOD brief included a planned descent with the rogue engine at cruise thrust, managing any excess speed with speed brake, if the T/lever was still immovable at 10,000' the intent was to shut the engine down.
In the event it became necessary to shut the engine down and continue with an engine inop approach, the T/lever finally freed up at about 2,500'. It was quite interesting trying to manually handle the other three T/levers with the 'rogue' stuck in the cruise position.
After landing the engineers spent an hour chipping ice out of the No3 engine pylon, apparently the drain holes had somehow become blocked allowing the pylon to fill with water during the earlier turnaround which, then of course, froze on the subsequent climb out.
Following heavy rain during the ground turnaround the subsequent departure and climb to cruise appeared normal, however upon making a step climb to FL370 we discovered the No3 T/Lever was immovable. We were able to accomplish the climb without difficulty and at the new cruise level the FCU provided substantially normal cruise thrust.
Suspecting ice build up had affected the T/lever control run, the TOD brief included a planned descent with the rogue engine at cruise thrust, managing any excess speed with speed brake, if the T/lever was still immovable at 10,000' the intent was to shut the engine down.
In the event it became necessary to shut the engine down and continue with an engine inop approach, the T/lever finally freed up at about 2,500'. It was quite interesting trying to manually handle the other three T/levers with the 'rogue' stuck in the cruise position.
After landing the engineers spent an hour chipping ice out of the No3 engine pylon, apparently the drain holes had somehow become blocked allowing the pylon to fill with water during the earlier turnaround which, then of course, froze on the subsequent climb out.
Joined: Dec 1998
Posts: 163
Likes: 2
From: PENang, Malaysia
Slightly different problem on the A300/310. The teflon inner liner was prone to "snagging " the cable. The solution was to turn on the engine anti-ice to " overheat " the pylon and throttle cable run.
Joined: Nov 1999
Aviation Qualifications: ATPL
Posts: 3,150
Likes: 744
From: UK
@spannersatcx,
The A330 incident mentioned was not due to 'jammed thrust levers' but severe fuel contamination affecting various engine fuel componenets, including the stator vane actuator system.
The A330 incident mentioned was not due to 'jammed thrust levers' but severe fuel contamination affecting various engine fuel componenets, including the stator vane actuator system.
Joined: Jul 2000
Posts: 351
Likes: 0
From: Nirvana..HAHA..just kidding but,if you can tell me where it is!
Cranfield,Jodel,1980....
After a 5000' climb I found that the throttle remained at full power...
Turned back towards the field,pulled the mixture,and deadsticked back on the runway.
Some consternation to owner,who viewed the tip dihedral as a crashed aircraft,due heat shimmer on the hot tarmac!
Back to thread!
After a 5000' climb I found that the throttle remained at full power...
Turned back towards the field,pulled the mixture,and deadsticked back on the runway.
Some consternation to owner,who viewed the tip dihedral as a crashed aircraft,due heat shimmer on the hot tarmac!
Back to thread!
Joined: Sep 1999
Aviation Qualifications: ATPL
Posts: 99
Likes: 27
From: UK
It also happened to me on a L1011 in the late 90s. I seem to recall cruising at FL390 and on starting descent one of the thrust levers wouldn't move. The FE said that he had seen this before and selected Engine Anti-Ice on. After a couple of minutes the thrust lever moved again. I have no idea why.
