A380-800 Ground Operations
Thread Starter
Join Date: Sep 1999
Location: ME
Posts: 5,502
Likes: 0
Received 0 Likes
on
0 Posts
A380-800 Ground Operations
Taken from Jeppesen 10-1P2 for ATHENS....
First time that i have seen such restrictions for the A380, my question is why do they exist? Are the taxiways that narrow that they dont want engine FOD? Or?
As for
would lead me to believe that the airport isnt ready for the A380.
Engines 1 and 4 should be shut-down when vacating the RWY after landing started up for departure on the RWY. Taxiing should be performed on engines 2 and 3. Alternatively in order to minimize RWY occupancy, engines 1 and 4 should be started up on TWY D facing south, abeam link D2 for departure from RWY 03R, or on link D13 facing east for departure from RWY 21L. If engines 1 and 4 are started up prior to entering the RWY they should be kept at ground idle until lined up for departure
As for
In order to keep the required minimum edge clearances, judgemental oversteer shall be used
Usual disclaimers apply!
Join Date: Nov 1999
Location: EGGW
Posts: 843
Likes: 0
Received 0 Likes
on
0 Posts
Aother small point. No matter what 'flavour' of engines are installed it wont do them any good being started up then immediately being poked up to takeoff power without a warm up.
Join Date: Apr 2005
Location: Euroville
Posts: 455
Likes: 0
Received 0 Likes
on
0 Posts
As a general trend I've noticed more of this kind of crap sneaking into the Jepp briefings. I am probably wrong but I have the distinct feeling that they are being written so they can be held up and pointed out to the local NIMBYs as the airports swashbuckling and unique way of dealing with noise pollution.
One of the Sardinian airports had a similar note along the lines of "idle power only for taxi" when the taxiway was slightly uphill. We had a colleague so blinded by SOPs that he attempted it and started rolling backwards.
I don't know if the instructions above are related to FOD or another genuine hazard but if they are some over zealous attempt at noise abatement then I hope that those who have been put in charge of an A380 have the common sense to treat them with utter contempt.
One of the Sardinian airports had a similar note along the lines of "idle power only for taxi" when the taxiway was slightly uphill. We had a colleague so blinded by SOPs that he attempted it and started rolling backwards.
I don't know if the instructions above are related to FOD or another genuine hazard but if they are some over zealous attempt at noise abatement then I hope that those who have been put in charge of an A380 have the common sense to treat them with utter contempt.
Last edited by Telstar; 17th Aug 2012 at 15:14.
Join Date: Mar 2011
Location: engineer at large
Posts: 1,409
Likes: 0
Received 0 Likes
on
0 Posts
A380 requirements:
Runway: Min pavement width is 60m, with 75m preferred
Taxiway: Min pavement width is 25m, taxiway strip level width min 60m
Runway: Min pavement width is 60m, with 75m preferred
Taxiway: Min pavement width is 25m, taxiway strip level width min 60m
Last edited by FlightPathOBN; 17th Aug 2012 at 20:16.
Join Date: Mar 2011
Location: engineer at large
Posts: 1,409
Likes: 0
Received 0 Likes
on
0 Posts
They can have a stabilized shoulder that can count..not sure of the exact config at Heathrow...
looking quickly with Google, it appears that the North runway and taxiways have reinforced shoulders...
looking quickly with Google, it appears that the North runway and taxiways have reinforced shoulders...
Last edited by FlightPathOBN; 17th Aug 2012 at 21:52.
Probably simply the same reason 1 and 4 on the 380 don't have reverse thrust - they have more engine overhang than any other commercial craft except the Antonov Mryia or Spruce Goose.
File:Giant planes comparison.svg - Wikipedia, the free encyclopedia
Yep - which is why they aren't started up then immediately poked to takeoff power. You sit there occupying the runway until they have warmed up - or:
File:Giant planes comparison.svg - Wikipedia, the free encyclopedia
....it wont do them any good being started up then immediately being poked up to takeoff power without a warm up.
Alternatively in order to minimize RWY occupancy, (emphasis added) engines 1 and 4 should be started up on TWY D facing south,...... etc.
Join Date: Aug 2005
Location: ME
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
It may have something to do with brake heating. Today in Jeddah Emirates A380 requested nearest to their parking RW34L while everybody else were using 34R, and gave brake heating during prolonged taxi as a reason.
On the other day they were holding all traffic on the main taxiway for about 20 min as they could't taxi due to hot brakes. That was on departure by the way...
On the other day they were holding all traffic on the main taxiway for about 20 min as they could't taxi due to hot brakes. That was on departure by the way...
Last edited by Romasik; 19th Aug 2012 at 03:38.
Join Date: Mar 2011
Location: 0ft AGL
Age: 33
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
One of the other reasons might be to keep the TWY clean of debris.
While A380 might not receive any FOD during taxi it still can blow quite a lot of stuff onto TWY with 1 & 4 (even if the edges are clean, you never know) if it is not wide enough, in that case I believe TWY check will have to be performed by responsible personnel after A380 taxi, therefore probably delaying other a/c.
While A380 might not receive any FOD during taxi it still can blow quite a lot of stuff onto TWY with 1 & 4 (even if the edges are clean, you never know) if it is not wide enough, in that case I believe TWY check will have to be performed by responsible personnel after A380 taxi, therefore probably delaying other a/c.
Join Date: May 2009
Location: Australia, maybe
Posts: 559
Likes: 0
Received 0 Likes
on
0 Posts
??? ... A380 FCOM (my bolding)
Outer engines less susceptible to FOD, so I guess they don't want the airport signs blown away.
Little, if any, power above idle thrust can be necessary to move the aircraft (e.g. approximately up t0 10 % THR at heavy weight, with a uphill taxi slope). Excessive thrust application on engines can result in exhaust-blast damage (e.g. on airport signs). The Flight Crew should use symmetrical thrust. When the aircraft begins to move, less thrust is necessary.
If the inner engines are located over unconsolidated or unprepared ground during taxi, avoid high thrust settings on the inner engines (i.e. engine ingestion (FOD) risk increases). If additional thrust is necessary, the Flight Crew should preferably use the outer engines.
If the inner engines are located over unconsolidated or unprepared ground during taxi, avoid high thrust settings on the inner engines (i.e. engine ingestion (FOD) risk increases). If additional thrust is necessary, the Flight Crew should preferably use the outer engines.
Last edited by Trent 972; 19th Aug 2012 at 05:29. Reason: formatting
