A 3 2 0 Thrust Ratings
Thread Starter
Join Date: Jun 2006
Location: Middle East
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
A 3 2 0 Thrust Ratings
Hi Guys,
Any smart guy could tell me how to use the Thrust R A T I N G S - Graph in Fcom 3.05.06 Page 3, And could you also tell me about the COrner Point how to know if its < or > than OAT !?!?
Thanks Guys
Any smart guy could tell me how to use the Thrust R A T I N G S - Graph in Fcom 3.05.06 Page 3, And could you also tell me about the COrner Point how to know if its < or > than OAT !?!?
Thanks Guys
Join Date: Oct 2009
Location: UK
Posts: 1,270
Likes: 0
Received 0 Likes
on
0 Posts
Hi Captain_BH,
I'm not that smart - but in the example they give, it shows how to estimate the N1 Flex is about 85 and a bit %. (50C Flex, P Alt 2,000 ft and OAT = -10C)
If you look in the top right hand corner (Corner Point), they have drawn a graph showing flat rating temp v P ALT curve. At a Pressure Alt of 2,000 ft, the curve is intercepted at 40 degs C.
In this particular example, since the OAT < than the "Corner Point" value (Flat rating Temperature) then no correction is required.
I'm not that smart - but in the example they give, it shows how to estimate the N1 Flex is about 85 and a bit %. (50C Flex, P Alt 2,000 ft and OAT = -10C)
If you look in the top right hand corner (Corner Point), they have drawn a graph showing flat rating temp v P ALT curve. At a Pressure Alt of 2,000 ft, the curve is intercepted at 40 degs C.
In this particular example, since the OAT < than the "Corner Point" value (Flat rating Temperature) then no correction is required.
Last edited by rudderrudderrat; 9th Jul 2011 at 18:19.
