A318/19/20/21 Aircraft electrical power down.
Thread Starter
Join Date: Feb 2006
Location: london
Age: 65
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
A318/19/20/21 Aircraft electrical power down.
What is the correct way of avoiding the APU flap door staying open while shutting down power from the aircraft?
Join Date: Oct 1998
Location: CGK to HKG
Posts: 249
Likes: 0
Received 0 Likes
on
0 Posts
Ganard, suspect that you are too quick with switching off the batteries.
Extract from A330 should be similar:
On the APU page of the SD:
- a short time after the APU speed decreased to 7%, the FLAP OPEN indication goes off.
- 30 seconds after the APU speed decreased to 7%, the APU speed and EGT indications show XX (amber).
NOTE: Switching the Batteries OFF before the APU air inlet flap is completely closed may cause smoke in the cabin during the next flight, therefore wait as long till SD shows crosses XX in amber to be sure the shut down process is finished.
So waiting 60 secs minimum after seeing flap OPEN indication disappear and then deselect BATT1, BATT2 and APU BATT should improve your lot...
Of course this maybe completely different to the Baby Buses..
Extract from A330 should be similar:
On the APU page of the SD:
- a short time after the APU speed decreased to 7%, the FLAP OPEN indication goes off.
- 30 seconds after the APU speed decreased to 7%, the APU speed and EGT indications show XX (amber).
NOTE: Switching the Batteries OFF before the APU air inlet flap is completely closed may cause smoke in the cabin during the next flight, therefore wait as long till SD shows crosses XX in amber to be sure the shut down process is finished.
So waiting 60 secs minimum after seeing flap OPEN indication disappear and then deselect BATT1, BATT2 and APU BATT should improve your lot...
Of course this maybe completely different to the Baby Buses..
Join Date: Mar 2006
Location: Choroni, sometimes
Posts: 1,974
Likes: 0
Received 0 Likes
on
0 Posts
Ehrrm, not current anymore, but AFAIK Apu Flap is controlled via the ECB which is powered by the BAT BUS. The BAT BUS is supplied by DC BUS 1and/or 2 and/or the batteries.
So if EXT ELEC ON, the BAT BUS is supplied even with batteries of and the Flap will close.
My 2 cents.
So if EXT ELEC ON, the BAT BUS is supplied even with batteries of and the Flap will close.
My 2 cents.
Join Date: Oct 2007
Location: Greece
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
Only if you have no external power you should wait 2 minutes before turning off BATTs OFF to be sure that flap has closed. With external power ON, DC BATT bus is powered, can switch off BATTs without delay. You could confirm flap closed on APU page before deselecting external power off.