Use of transponder on the ground
Thread Starter
Join Date: Nov 2008
Location: Next door
Age: 75
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
Use of transponder on the ground
It does not give this as a requirement in our SOPs.
It does mention in many aerodrome booklets that transponder use is required during taxy.
There are many large airfields I visit in Europe and the Middle East and Asia where I am told by the trainers it is required (even though this is not mentioned in the booklets or the Jeps area supplement).
Anyone know where this is written please?
It does mention in many aerodrome booklets that transponder use is required during taxy.
There are many large airfields I visit in Europe and the Middle East and Asia where I am told by the trainers it is required (even though this is not mentioned in the booklets or the Jeps area supplement).
Anyone know where this is written please?
Join Date: Feb 2000
Location: Hove
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
Don't know where its written, but its down to the new generation of surface movement radars (radar in this context is probably the wrong word!) which rely on transponder returns to generate the ground movement picture. Hence no transponder - No display of traffic to the controller.
Join Date: Aug 2007
Location: Germany
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
In FRA it is done by software and they had a long way to go before this feature was implemented. So before the software was able to link the callsign to the blip it was just a blip without any further information.
Join Date: Mar 2006
Location: USA
Posts: 2,531
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by FLX/MCT
Can the use of Transponder on the ground be the cause of a TCAS TA/RA or is there a special "ground mode"?
Join Date: Jul 2008
Location: FORT MAQTA
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Spot on Check Airman.
FLX/MCT- while taxying you can turn the TCAS off while leaving your transponder operating if required by local procedures.
Speaking only for Airbus their FCOM 1.34.80 states in part that "... if windshear, stall or GPWS are triggered or aircraft below 500ft agl all TCAS aural messages are suppressed." (minor alt differences depending on whether climbing or descending).
Drivers of other types can speak to their specific aircraft.
FLX/MCT- while taxying you can turn the TCAS off while leaving your transponder operating if required by local procedures.
Speaking only for Airbus their FCOM 1.34.80 states in part that "... if windshear, stall or GPWS are triggered or aircraft below 500ft agl all TCAS aural messages are suppressed." (minor alt differences depending on whether climbing or descending).
Drivers of other types can speak to their specific aircraft.
Join Date: Apr 2001
Location: JAAland
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
I have started to always put the transponder to XPDR when the push/taxi starts because I don't bother remembering the airports where this is a requirement or not.
If the airport isn't equipped with this new transponder surface monitor system (A-SMGCS?) I have been told that "my" squawk won't bother anyone.
And the data sent out are not capable of trigging TCAS equipment (XPDR-mode)
If the airport isn't equipped with this new transponder surface monitor system (A-SMGCS?) I have been told that "my" squawk won't bother anyone.
And the data sent out are not capable of trigging TCAS equipment (XPDR-mode)
Join Date: Nov 2008
Location: UK
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Just a little insight from Air Taffic here.
If you are operating on an airfield that employs ground movement radar. Transponder use can be required, in which case the radar picks you up and identifies you on the blip on the airfield layout they have. Used at places where low vis often occurs, or large airfields to prevent collision and to increase efficency.
In terms of airfields not employing surface movement radar, the radar room doesn't get interference from your transponder being active whilst on the ground, as SSR radar supresses transponder codes on the ground, or airfields would just be a haze of transponder codes.
If you are operating on an airfield that employs ground movement radar. Transponder use can be required, in which case the radar picks you up and identifies you on the blip on the airfield layout they have. Used at places where low vis often occurs, or large airfields to prevent collision and to increase efficency.
In terms of airfields not employing surface movement radar, the radar room doesn't get interference from your transponder being active whilst on the ground, as SSR radar supresses transponder codes on the ground, or airfields would just be a haze of transponder codes.
Can the use of Transponder on the ground be the cause of a TCAS TA/RA or is there a special "ground mode"?
A Mode A/C only transponder has no such output, so it should be switched on only for departure and off again after landing.
ACAS on the ground
Guidance can be found here http://www.eurocontrol.int/msa/galle...date_Nov07.pdf in the Eurocontrol Bulletin 9.
Other bulletins can be found here EUROCONTROL - ACAS II Bulletins and Safety Messages
All well worth reading.
MM
Other bulletins can be found here EUROCONTROL - ACAS II Bulletins and Safety Messages
All well worth reading.
MM
Join Date: Feb 2007
Location: Netherlands
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
Flying out of Amsterdam I know its mentioned somewhere in the Jepp plates in the airport briefing and ATC well call you on it if you do not have your transponder on XPDR mode as soon as you start taxiing.
Join Date: Mar 2006
Location: TLV
Age: 50
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
I have come across airports that tell you to turn it on on the ground, and some airports that specifically tell you to turn it off. Some even state the requirement in the ATIS.
By 'it' i mean the transponder. TCAS should always be off on the ground, so you should use the 'auto' position on your box, or 'xponder'.
I guess the safe way would be to use the transponder on the ground, and let ATC tell you to turn it off if it bothers them.
My airline has put a line in the before start checklist and in the shutdown checklist for remembering to turn it on before push-back and off when at the gate.
By 'it' i mean the transponder. TCAS should always be off on the ground, so you should use the 'auto' position on your box, or 'xponder'.
I guess the safe way would be to use the transponder on the ground, and let ATC tell you to turn it off if it bothers them.
My airline has put a line in the before start checklist and in the shutdown checklist for remembering to turn it on before push-back and off when at the gate.
Transparency International
From a number of sources [Eurocontrol ++] we have collected the following:
Advanced Surface Movement Guidance & Control System (A-SMGCS) is in an operational test phase at CDG, VIE and MUC but has also been installed (or are under installation) at a bunch of other european airports like: CGN, LYS, TLS, MAD, Barcelona, Oslo, Stockholm, Prague, FCO, Malpensa, AMS, Riga, LGW, LHR, BRU, FRA, HAM, DUS, Palma De Mallorca, CPH, Zurich, Geneva, Paris Orly.
As I understand it, Eurocontrol likes you to turn it on from the time you request push.
Advanced Surface Movement Guidance & Control System (A-SMGCS) is in an operational test phase at CDG, VIE and MUC but has also been installed (or are under installation) at a bunch of other european airports like: CGN, LYS, TLS, MAD, Barcelona, Oslo, Stockholm, Prague, FCO, Malpensa, AMS, Riga, LGW, LHR, BRU, FRA, HAM, DUS, Palma De Mallorca, CPH, Zurich, Geneva, Paris Orly.
As I understand it, Eurocontrol likes you to turn it on from the time you request push.
Join Date: Mar 2006
Location: TLV
Age: 50
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
This just in:
To: All airlines operating into the United Kingdom
Dear Colleagues,
This message is being circulated to highlight an amendment to the UK AIP with regard to the requirement for use of Squawk A2000 on ground with effect from 12 February 2009. In essence the change seeks to harmonise the use of Squawk A2000 on ground as follows:
"Unless otherwise instructed by ATC, Mode S transponder equipped aircraft on the aerodrome surface should select Mode A code 2000 when under tow; or parked and prior to selecting OFF or STDBY."
Dear Colleagues,
This message is being circulated to highlight an amendment to the UK AIP with regard to the requirement for use of Squawk A2000 on ground with effect from 12 February 2009. In essence the change seeks to harmonise the use of Squawk A2000 on ground as follows:
"Unless otherwise instructed by ATC, Mode S transponder equipped aircraft on the aerodrome surface should select Mode A code 2000 when under tow; or parked and prior to selecting OFF or STDBY."
Join Date: Dec 2005
Location: Europe
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
if u have TCAS, just select the mode XNDR or ALTOFF NOT TA/RA.
It is especially important during low vis weather,so controller can track your progress.TARA only when entering runway in use.It is nerve recking to see alt reporting of an aircraft taxiing on // taxiway when you are taking off in low vis conditions.
If it is not written on your Jepps, you dont need to do it unless of course your SOPS require you to.
Captstd
It is especially important during low vis weather,so controller can track your progress.TARA only when entering runway in use.It is nerve recking to see alt reporting of an aircraft taxiing on // taxiway when you are taking off in low vis conditions.
If it is not written on your Jepps, you dont need to do it unless of course your SOPS require you to.
Captstd
Last edited by Boingboingdriver; 1st Dec 2008 at 16:27.
Join Date: Mar 2001
Location: I wouldn't know.
Posts: 4,500
Likes: 0
Received 0 Likes
on
0 Posts
Really depends on the kit you have equipped. Ours for example are set in AUTO and do as Mode S Transponders should: set the ground flag when on the ground so you won't get any altitude reports from them.
Join Date: Mar 2003
Location: ? ? ?
Posts: 2,281
Likes: 0
Received 0 Likes
on
0 Posts
Miles Magister post #13 with it's links explains the scenario as best as possible.
Ciao
Ciao