auto pilot ground system test B737-800
Thread Starter
Join Date: Dec 2000
Location: very close to STN!!
Posts: 523
Likes: 0
Received 0 Likes
on
0 Posts
auto pilot ground system test B737-800
here in my hands i have page 4.10.20 on which i find under the "autopilot disengage light"... illuminated red....
steady for any of the following conditions....stabilizer out of trim below 800 ft RA on dual channel approach...ALT ACQ mode inhibited during A/P go around if stabilizer not trimmed for single A/P operation...disengage light test switch held in position 2...
all of which i understand and have seen for years but next is one i have never seen and cannot find any other reference in same operations manual...
"automatic ground system test fail."
does anyone out there know what this refers to? we have never seen it before, but will be the first to admit that i have missed things before.
any help will be greatly appreciated.
cheers and best rear guards;
steady for any of the following conditions....stabilizer out of trim below 800 ft RA on dual channel approach...ALT ACQ mode inhibited during A/P go around if stabilizer not trimmed for single A/P operation...disengage light test switch held in position 2...
all of which i understand and have seen for years but next is one i have never seen and cannot find any other reference in same operations manual...
"automatic ground system test fail."
does anyone out there know what this refers to? we have never seen it before, but will be the first to admit that i have missed things before.
any help will be greatly appreciated.
cheers and best rear guards;
Join Date: Dec 2004
Location: E&E compartment
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
applicable as well for the classics 4.10.17 ops man. vol. II
I believe it is a grd system test done by maintenance. Steady red illumination of the light meaning failure of the test.
I believe it is a grd system test done by maintenance. Steady red illumination of the light meaning failure of the test.
Join Date: Apr 2004
Location: near EDDF
Posts: 775
Likes: 0
Received 0 Likes
on
0 Posts
Steady Red A/P Warning Light will come on...
...
- the airplane is on the ground and the FCC fails the power up test
...
- the light will also come on if the DFCS is in BITE or if the other FCC part number is invalid.
...
- the airplane is on the ground and the FCC fails the power up test
...
- the light will also come on if the DFCS is in BITE or if the other FCC part number is invalid.