ICOM ICR5 Scanner Programming problems
Thread Starter
Joined: Jan 2002
Posts: 186
Likes: 0
From: on the edge
ICOM ICR5 Scanner Programming problems
Does anyone else have one great little scanners? If so, how on earth did you program the frequencies into it? I've read the instructions over and over again, but I cannot get a set of frequencies put into the machine. Can anyone assist?
Dir. PPRuNe Line Service
Joined: Dec 1998
Posts: 563
Likes: 4
From: Southern England
Dir. PPRuNe Line Service
Joined: Dec 1998
Posts: 563
Likes: 4
From: Southern England
How about this?
http://www.ukmidlandscanner.co.uk/r5rev.htm
About half-way down, read the paragraph that starts
"I have to be really honest here and admit that I found it very hard going to program this scanner at first. "
(I wish I hadn't started researching this... I'm soooo tempted to upgrade my ancient AR 1500 to an icom icr-20...)
http://www.ukmidlandscanner.co.uk/r5rev.htm
About half-way down, read the paragraph that starts
"I have to be really honest here and admit that I found it very hard going to program this scanner at first. "
(I wish I hadn't started researching this... I'm soooo tempted to upgrade my ancient AR 1500 to an icom icr-20...)
