A380 low at Melbourne
It has been known for decades that the approach phase is perhaps the most critical phase and during which most errors occur and incidents result;
The approach and landing phase is the most critical as you said, but more errors are made in the pre-departure phase of flight. I think that is something worth knowing and thinking about when I see people rushing like mad to claw back 5 minutes.
Cheers
Join Date: Jun 2006
Location: Australia
Posts: 1,186
Likes: 0
Received 0 Likes
on
0 Posts
If it doesn't settle down you need to reduce the automation and, in the worst case, fly the plane.
So you "reduce" the automation and see if that works. How long do you wait for reduced automation to give the desired result before gasp horror you actually are forced to fly the plane. I suggest that instead of "reducing" automation if it doesn't settle down, it would be prudent to disengage the automation immediately and seamlessly fly the plane where you want it to go. Of course if the pilot lacks the manual flying skills to do so, then simply reduce the automation as you say and send out a PAN before resorting to manual flying.
Join Date: Jun 2001
Location: Rockytop, Tennessee, USA
Posts: 5,898
Likes: 0
Received 1 Like
on
1 Post
So you "reduce" the automation and see if that works. How long do you wait for reduced automation to give the desired result before gasp horror you actually are forced to fly the plane. I suggest that instead of "reducing" automation if it doesn't settle down, it would be prudent to disengage the automation immediately and seamlessly fly the plane where you want it to go.
The FAA and Boeing talk about 'levels' of automation from one to four. I think Airbus talks about similar levels with less automation being more 'direct'.
As Airbus says in their SOP treatise on 'Optimum Use of Automation':
At any time, if the aircraft does not follow the desired flight path and/or airspeed, do not hesitate to revert to a more direct level of automation, i.e.:
Revert from FMS-managed modes to selected modes; or,
Disconnect AP and follow FD guidance (if correct); or,
Disengage FD, select FPV (as available) and hand fly the aircraft, using raw data or visually (if in VMC); and/or,
Disengage the A/THR and control the thrust manually.
Revert from FMS-managed modes to selected modes; or,
Disconnect AP and follow FD guidance (if correct); or,
Disengage FD, select FPV (as available) and hand fly the aircraft, using raw data or visually (if in VMC); and/or,
Disengage the A/THR and control the thrust manually.
As usual, a lot of this philosophical stuff about levels of automation finds its way into the company pubs as CYA boilerplate paragraphs and filters down to the line through the training department.
On the particular KIX approach I was discussing earlier, you could go into a heading and vertical speed or altitude hold mode and let the plane settle down as it made the turn to intercept the ILS and then reselect LNAV/VNAV (on a Boeing) and then go to approach mode when the signal was stable.
You certainly could turn the autopilot off and hand fly the approach but recently that is somewhat frowned upon where I work since you had briefed a coupled approach.
Even following the glide path down with vertical speed if it doesn't capture for some reason is now considered a deviation from your planned procedure. I'm told that you should go missed, request holding, reassess your nav status, call the company and speak to a subject matter expert if required and rebrief the approach with reduced nav automation capability. You've got plenty of gas, right?
Guest
Join Date: Apr 2009
Location: On the Beach
Posts: 3,336
Likes: 0
Received 0 Likes
on
0 Posts
If, in fact, the flight was cleared for an RNP AR approach, not only is that an instrument approach, it requires specific training and flight crew operating procedures. The database isn't supposed to be messed with. Performance-based navigation actually means what it says with RNP AR IAPs. Deviation from the VNAV path, exceeding maximum segment speed, or deviating from the lateral path all invalidate the approach.
Join Date: Jul 2000
Location: Dubai - sand land.
Age: 55
Posts: 2,832
Received 0 Likes
on
0 Posts
And these RNP approaches are NOT flown in APP mode, but rather in NAV/DES so should follow the vertical constraint...
I have personally however had a colleague try and stuff up the approach to 34 in MEL with finger trouble and only intervention from my side stopped us going below a waypoint altitude constraint...
Easy to have finger trouble on such a tiring pattern that we fly here!
I have personally however had a colleague try and stuff up the approach to 34 in MEL with finger trouble and only intervention from my side stopped us going below a waypoint altitude constraint...
Easy to have finger trouble on such a tiring pattern that we fly here!
Guest
Join Date: Apr 2009
Location: On the Beach
Posts: 3,336
Likes: 0
Received 0 Likes
on
0 Posts
Attached is the Austrian AIP chart for the RNAV-P (RNP) RWY 34 approach. If entering at either LAVER or GOOLA the specified speed (or less) and RF legs must be followed. The vertical profile (VNAV or VPATH) must entered not less than 2,000. 3,000 or higher must be maintain untl ML632 or ML642. ATC cannot intervene on either of these transitions other than to assign a speed less than the maximum specified. ATC can vector to an extension of the final approach course, in which case the approach must begin not later than MEXUN. In the case of a vector to the final outside of MEXUN the last assigned altitude should be maintained until intercepting the VPATH, but descending to 2,000 after SUDOS to intercept the VPATH at 2,000 would be acceptable with ATC concurrence.
Oz also provides an OEI procedure with their RNP AR approaches. Page 2 would apply only in that case and only with a declaration of the engine failure.
Oz also provides an OEI procedure with their RNP AR approaches. Page 2 would apply only in that case and only with a declaration of the engine failure.
Join Date: Jun 2004
Location: Surrounding the localizer
Posts: 2,200
Likes: 0
Received 2 Likes
on
1 Post
As a general comment regarding RNP approaches in MEL, I've found over the years that it all goes well, until ATC decide to vector you off, or worse keep you high and then expect you to be back on profile and speed etc.
I even asked the ATCO why clear us for the approach and then vector us off..etc his reply "because that's what we do"
As I said, just a general comment, but it does add complexity to an approach that is further complicated by various operator restrictions and physical limitations.
I even asked the ATCO why clear us for the approach and then vector us off..etc his reply "because that's what we do"
As I said, just a general comment, but it does add complexity to an approach that is further complicated by various operator restrictions and physical limitations.
Join Date: Apr 2014
Location: indiana
Age: 63
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Automation and competency in general.
At what point does the reliance on, and extended use of, automation create a critical dysfunction in the thought processes and mechanics of flying?
And at what stage of training (prior non-automation flight experience) does that impact occur?
As an example, at some point (already in testing), there will be automobiles with with autopilot modes which can be engaged and/or disengaged. Theoretically, the disengagement mode would be activated for problem situations to allow the human with driving experience to control the situation. That would be appropriate for a skilled driver. At some point however, there will be "drivers" of automobiles who have essentially been passengers for a decade and will be highly unskilled for actually driving even in basic control situations (breaking distance calculations, turning at speed, etc.) let alone high traffic situations and poor road conditions such as ice, rain, snow.
And at what stage of training (prior non-automation flight experience) does that impact occur?
As an example, at some point (already in testing), there will be automobiles with with autopilot modes which can be engaged and/or disengaged. Theoretically, the disengagement mode would be activated for problem situations to allow the human with driving experience to control the situation. That would be appropriate for a skilled driver. At some point however, there will be "drivers" of automobiles who have essentially been passengers for a decade and will be highly unskilled for actually driving even in basic control situations (breaking distance calculations, turning at speed, etc.) let alone high traffic situations and poor road conditions such as ice, rain, snow.
Guest
Join Date: Apr 2009
Location: On the Beach
Posts: 3,336
Likes: 0
Received 0 Likes
on
0 Posts
huatney1:
The second time they did that, I would refuse the RNP AR approach.
As a general comment regarding RNP approaches in MEL, I've found over the years that it all goes well, until ATC decide to vector you off, or worse keep you high and then expect you to be back on profile and speed etc.
I even asked the ATCO why clear us for the approach and then vector us off..etc his reply "because that's what we do"
As I said, just a general comment, but it does add complexity to an approach that is further complicated by various operator restrictions and physical limitations.
I even asked the ATCO why clear us for the approach and then vector us off..etc his reply "because that's what we do"
As I said, just a general comment, but it does add complexity to an approach that is further complicated by various operator restrictions and physical limitations.
Does the approach need to be redesigned?
Guest
Join Date: Apr 2009
Location: On the Beach
Posts: 3,336
Likes: 0
Received 0 Likes
on
0 Posts
Chris2303:
The approach is fine. It should have been designed with air traffic management in mind. If not, then the Oz aviation authority issued incorrect specs to the procedures designers. I doubt that was the case. Sounds like an ATC facility problem to me.
Does the approach need to be redesigned?
Join Date: Jun 2001
Location: Rockytop, Tennessee, USA
Posts: 5,898
Likes: 0
Received 1 Like
on
1 Post
From ATSB website these guys were 15 nm south though and perhaps vectored for the long final.
Join Date: Jun 2001
Location: Rockytop, Tennessee, USA
Posts: 5,898
Likes: 0
Received 1 Like
on
1 Post
As the facts in this case are yet to be revealed I cannot comment specifically on what happened to the A380 however, what I can say regarding any type of GNSS approach (RNAV-Z or RNP-AR) is that you must not arm the approach pushbutton unless the ATC assigned altitude and the IAF (or suitable Direct to waypoint) altitude are the same, otherwise the FMGC switches from NAV to FINAL APP mode and therefore will drop down to the NEXT altitude constraint as per the FMGC constraints, thereby bypassing the relevant safe altitude even if it is still selected in the FCU.
This was why, some time back Airservices changed the terminology to "when established cleared Runway xx x approach" that is to say:established on the approach itself and not simply tracking to intercept a waypoint on the approach.
This was why, some time back Airservices changed the terminology to "when established cleared Runway xx x approach" that is to say:established on the approach itself and not simply tracking to intercept a waypoint on the approach.
It will be interesting to see whether they were cleared for the approach out over the water and selected approach mode too soon with a missing waypoint constraint.
Guest
Join Date: Apr 2009
Location: On the Beach
Posts: 3,336
Likes: 0
Received 0 Likes
on
0 Posts
Rule3:
I caught one of those, obviously missed that one. In any case the chart I posted should make the location obvious.
Re post27 by aterpster.
"Austrian AIP" Mate, there are no Kangaroos in Austria.
"Austrian AIP" Mate, there are no Kangaroos in Austria.
Guest
Join Date: Apr 2009
Location: On the Beach
Posts: 3,336
Likes: 0
Received 0 Likes
on
0 Posts
Aibubba:
Attached are the Jepp charts for the procedure in question. However, Emirates was likely using Lido charts.
Thanks! I'm not used to that chart format, hopefully I wouldn't have missed it but I certainly might have.