Atlas 747 Nose gear collapse
Join Date: Dec 2000
Location: Hilversum, the netherlands
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Gearpin stowage
A question for all you 747 guys and girls:
In our (KLM) a/c we stow the gearpins in the cockpit and not in the E/E compartment, for obvious reasons.
This mod must have saved us a lot of trouble in the past 30 years, I believe.
Regards, Ballpoint.
In our (KLM) a/c we stow the gearpins in the cockpit and not in the E/E compartment, for obvious reasons.
This mod must have saved us a lot of trouble in the past 30 years, I believe.
Regards, Ballpoint.
I had a quick look at it today, driving past in the crew bus to our plane. Not much to see, just the nose gear doors a bit bent.
There may have been damage elsewhere, but I didn't get a good enough look to find out.
There may have been damage elsewhere, but I didn't get a good enough look to find out.
Only half a speed-brake
I am very padantic too, I believe you have to be indeed. I've 400 hours of accident/incident free flying in my logbook that says so.
And now it is time I go look for other nick-name.
FlightDetent (exit the scene)
And now it is time I go look for other nick-name.
FlightDetent (exit the scene)
I thought I wouldn't order a Personal Title to help offset the many thousands of pounds a month it costs to run PPRuNe. Nah... I'll just sit here and moan about it.
Thread Starter
Join Date: Apr 2003
Location: In-front of the keyboard
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Being a Bus diver and not a Boeing Engineer, here is a sketchy outline view (RUMOUR) of what I was told happened.
Apparently the said aircraft required the landing gear selector unit (ie the gear lever quadrant) to be partially or wholly replaced. Problem was that as the gear wasn't actually being directly worked on and hence the required pins were not in place. As the new equipment was being replaced, not noticed, the selection of the new equipment was at UP, CAUSING GEAR RETRACTION!!
Rumour not fact but most likely very correct form a good source.
Cheers GD
Apparently the said aircraft required the landing gear selector unit (ie the gear lever quadrant) to be partially or wholly replaced. Problem was that as the gear wasn't actually being directly worked on and hence the required pins were not in place. As the new equipment was being replaced, not noticed, the selection of the new equipment was at UP, CAUSING GEAR RETRACTION!!
Rumour not fact but most likely very correct form a good source.
Cheers GD