Bell 206 B3 hydraulic problem
Thread Starter
Join Date: Feb 2009
Location: Nerd-land
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Bell 206 B3 hydraulic problem
Hi
Although PSI gauge is in green and pressure at hydraulic amplifiers is nominal there is no hydraulic power at controls
Helicopter was park without engine for few months.
Please advice on this issue or direct me to other maintenance forum
thank you
Although PSI gauge is in green and pressure at hydraulic amplifiers is nominal there is no hydraulic power at controls
Helicopter was park without engine for few months.
Please advice on this issue or direct me to other maintenance forum
thank you
Join Date: May 2007
Location: Merriott, Somerset, UK
Age: 78
Posts: 229
Received 0 Likes
on
0 Posts
Its 30 years since I last worked on the B206, but I have a distant memory of an Hydraulic shut off switch on the instrument panel.
Go and have a look.
Tony
Go and have a look.
Tony
Umm... the B206 doesn't have a hydraulic pressure gauge.
Are you referring to the pressure from a ground test rig? If so, check the connections, check HYD switch is ON.
If the HYD circuit breaker is OUT, you will still get hyd power as it is a failsafe switch and requires electrical power to be turned OFF.
Are you referring to the pressure from a ground test rig? If so, check the connections, check HYD switch is ON.
If the HYD circuit breaker is OUT, you will still get hyd power as it is a failsafe switch and requires electrical power to be turned OFF.