Anyone using flitestar....problem with Navdata
Thread Starter
Joined: Jul 2002
Posts: 524
Likes: 0
From: uk
Anyone using flitestar....problem with Navdata
As some may already know, I have been playing with Flitestar VFR today! Anyway, I installed the Navdata as it says but when I look at my local area there are few VITAL things missing...I just wondered if this was true for other users:
L975...class A, runs just south of my local airfield...very important that I know where it is with regards to my flightplaning.
B39...not there again
B3...not there
Also, it doesn't say frequencies of CTA's/CTR's. It also, to my amazement doesn't say what class they ARE!? Only in UK, it duplicates the airspace with a boundarylayer, you have to click seperatley on the boundary layer to find out what class airspace it is....otherwise, outside the UK it doesn't say....?! I just says either "CTA" or "CTR"..
Any comments much appreciated.
L975...class A, runs just south of my local airfield...very important that I know where it is with regards to my flightplaning.
B39...not there again
B3...not there
Also, it doesn't say frequencies of CTA's/CTR's. It also, to my amazement doesn't say what class they ARE!? Only in UK, it duplicates the airspace with a boundarylayer, you have to click seperatley on the boundary layer to find out what class airspace it is....otherwise, outside the UK it doesn't say....?! I just says either "CTA" or "CTR"..
Any comments much appreciated.
Joined: May 2001
Posts: 4,729
Likes: 0
From: 75N 16E
You can buy them from any good pilot shop [one begining with T and ending in sair ...so I don't get done for advertising
] or directly from Jepp [on their website I think]. They're just calibrated digitized charts, same as the paper ones...
Cheers
EA
] or directly from Jepp [on their website I think]. They're just calibrated digitized charts, same as the paper ones...Cheers
EA
