Puma crewman harness info
Thread Starter
There is a 1/32 wessex
both HC2 and HU5 kits
https://www.florymodels.org/fly-132-westland-wessex
https://www.modelhobbies.co.uk/fly-1...0-250031-p.asp
both HC2 and HU5 kits
https://www.florymodels.org/fly-132-westland-wessex
https://www.modelhobbies.co.uk/fly-1...0-250031-p.asp
https://forum.largescaleplanes.com/i...thern-ireland/
Join Date: Feb 2006
Location: Hanging off the end of a thread
Posts: 33,064
Received 2,937 Likes
on
1,252 Posts
https://www.britmodeller.com/forums/...pmg-and-mount/
note the little rubber bump stops above the doors were also red, they were for the cowling to rest on when you were working on the engines. Also the hydraulic connections on the port side aft of the door were I think Red too.
note the little rubber bump stops above the doors were also red, they were for the cowling to rest on when you were working on the engines. Also the hydraulic connections on the port side aft of the door were I think Red too.
Thread Starter
https://www.britmodeller.com/forums/...pmg-and-mount/
note the little rubber bump stops above the doors were also red, they were for the cowling to rest on when you were working on the engines. Also the hydraulic connections on the port side aft of the door were I think Red too.
note the little rubber bump stops above the doors were also red, they were for the cowling to rest on when you were working on the engines. Also the hydraulic connections on the port side aft of the door were I think Red too.
Thread Starter
Yes, it’s not done yet. I’ve got the final weathering to do when it’s done so no more handling the kit. I’m in two minds as to whether to scratchbuild the Nightsun just to add more detail. Then the pole it’s going to be mounted on, I’m inclined to go with a carbon item this time rather than the go to acrylic/brass tube.
Join Date: Feb 2006
Location: Hanging off the end of a thread
Posts: 33,064
Received 2,937 Likes
on
1,252 Posts
Thread Starter
CAA audit in work this week, so time to get the iPad out and wait for knock on the door
Join Date: Feb 2006
Location: Hanging off the end of a thread
Posts: 33,064
Received 2,937 Likes
on
1,252 Posts
Good luck, just finished getting our new approvals sorted after 2 years of writing servicing schedules and the Expo to find it kept changing resulting in starting again.