Student instructed to Orbit on base
The scenario is the aircraft is on base leg, configured with approach flap, approach power, and ATC asks the student orbit, I think this overload for. the student so should "go-around" on to the dead side and rejoin
crosswind. Does anyone allow their students to orbit with the flaps out and low speed? |
Orbits anywhere in the circuit are a bad idea and only lead to confusion. Orbits for students should be an absolute no-no, assuming ATC know it's a student, and even worse if low hours.
|
I seem to remember I got quite a few "270s" before turning base and extended downwinds (towards mountains and up to being "forgotten" by ATC) when doing my PPL training in the US. Not a big problem if you are briefed what to expect before going solo.
|
Originally Posted by Less Hair
(Post 11618621)
I seem to remember I got quite a few "270s" before turning base and extended downwinds (towards mountains and up to being "forgotten" by ATC) when doing my PPL training in the US. Not a big problem if you are briefed what to expect before going solo.
|
Anyone remember the reason for the 'STUDENT' prefix? (UK)
|
Originally Posted by hobbit1983
(Post 11618651)
Anyone remember the reason for the 'STUDENT' prefix? (UK)
|
ATC should never instruct a student nor any pilot to orbit on base leg nor on final. Unfortunately this is not unknown. An orbit downwind should not be an issue when pilots are properly trained to do so.
|
Student should never orbit on base leg, if you can't continue the circuit you should Go-Around and you can do that from anywhere in the circuit patern. You should never orbit in the circuit unless told to do so by ATC and they should not do it with solo students, as stated use the STUDENT callsign. Maybe we should spend more time teaching people how to go around.
|
Here's an experience (quite some years ago) with a different take -
Me, back seat of a Cessna 172, experienced PPL plus instructor as a check flight for the former. In the circuit, instructed by ATC to advise turning base, call duly made, with response "caution wake vortex" (737 clearly visible just passing over the threshold). Also we hear another light aircraft joining behind us. Instructor immediately tells pilot to carry out a RH orbit. During the orbit (or maybe on completion, I can't remember) ATC calls "Instructor, report to ATC immediately on landing". I'm no expert (obviously) but even I twitched a bit! |
If a student pilot can’t orbit with anything else but clean configuration they have no business flying solo.
Flying a 360 at 70-80kts isn’t even slow flight. This is exactly why you train this presolo. |
This depends on where we are in the training program:
|
In all of our training activities, the instructor should weigh the benefit of any situation against the risk. Where the risk is judged to outweigh the benefit, then that situation should be avoided.
I would strongly suggest that asking an early solo student to orbit on base, or final is one of those situations. Whenever I send early solo students in the circuit, at a controlled airfield, I will have agreed with ATC on booking out, that they are not to be asked to orbit on base, or final. Orbiting in an uncontrolled circuit is very high risk, and should never happen! MJ:ok: Ps. And make sure they are using the 'Student' c/s prefix. as suggested earlier! |
A million years ago, at the University of Illinois Flight Institute, it was common practice that one would be given “disciplinary vectors” if one didn’t keep the pattern tight.
Wasn’t considered a big deal, as the instructor had already taught the student how to do basic maneuvers (and in fact spin) before he got turned loose in the pattern solo |
Originally Posted by Fl1ingfrog
(Post 11618703)
ATC should never instruct a student nor any pilot to orbit on base leg nor on final. Unfortunately this is not unknown. An orbit downwind should not be an issue when pilots are properly trained to do so.
The lack of awareness to avoid base leg orbits is invariably an ATCO tranining issue. A controller can qualify for his/her licence without any flying knowledge or experience. Many years ago NATS would include a PPL Course in their ATCO training, that has been reduced or even now removed completely. Those self sponsoring their training get no flying experience unless they chose to do it voluntarily, and thereby fund it themselves. I self funded my ATCO training and also a PPL. During my early post first solo circuit training I was instructed to “report final”, turned base, set up the descent, with 20 flap, power back and trimmed for the descent but then told to “orbit right” so that a scheduled flight could be lined up and depart ahead of me, not impressed to the extent I subsequently phoned the TWR ATCO to complain, he was totally oblivious to the problem that he had caused! |
It's in MATS Pt 1 - following the recommendation in the report below (mentioned in post #6)
Therefore, with the exception of instructions to go-around, instructions shall not be issued to aircraft in the final stages of approaching to land that would require it to deviate from its expected flight path unless exceptional and overriding safety considerations apply. https://assets.publishing.service.go...BABB_07-07.pdf |
excellent posts, especially Background Noise's post.
|
I had a student go around with full flap, fly the circuit with full flap, orbit late downwind with full flap, and subsequently land! The first he knew about it was during the debrief! I refused to fly with him thereafter, and suggested he sought another career option. Not sure if he’s still alive!
|
Originally Posted by mavisbacon
(Post 11625224)
The first he knew about it was during the debrief! I refused to fly with him thereafter, and suggested he sought another career option. Not sure if he’s still alive!
|
Situation that annoyed me, aircraft ahead and us in circuit asked to extend downwind, for aircraft joining long final. We were already further downwind than normally. Atc asked final traffic it's range.....6 miles!!
I said i was orbiting downwind, no one behind. Ridiculous. If my aircraft was solo student how far downwind would they have gone, far enough to lose site of the airfield? More than 2 in arrivals should join overhead. |
Originally Posted by B2N2
(Post 11618777)
If a student pilot can’t orbit with anything else but clean configuration they have no business flying solo.
Flying a 360 at 70-80kts isn’t even slow flight. This is exactly why you train this presolo. |
Originally Posted by memories of px
(Post 11618586)
The scenario is the aircraft is on base leg, configured with approach flap, approach power, and ATC asks the student orbit, I think this overload for the student so should "go-around" on to the dead side and rejoin
crosswind. |
Some years ago I was tasked with undertaking a Certificate of Airworthiness air test on a Seneca 2. Having completed the general handling plus the critical engine restart procedure my usual routine was then to climb to do the turbo charger performance check. During the descent I then did the shutdown of the starboard engine. For all my efforts I could not restart; informed ATC of the problem but was not declaring an emergency as I understood the problem and I had no additional concerns. I requested a straight in. ATC cleared me to long final No 2 but to be prepared to orbit to the right because of a helicopter in bound No 1 from the Gas Rigs. I explained to ATC that I was not prepared to orbit right but would orbit to the left. Before ATC could reply the helicopter captain intervened stating that he did not require a runway and can even hover if needed, "please clear the fixed wing No 1"; ATC then re-cleared me to land but to then vacate left onto the cross runway. I then informed ATC I would not be able to turn left but this time could turn right conditional on safely having slowed sufficiently by that point. The helicopter captain once again intervened stating that he can touch down precisely on the numbers and hover taxi clear, he would not need the rest of the runway.
This lack of understanding of the situation continued well after the landing without ATC enquiring from me what I was able to do before passing instructions. |
I had to smile reading this. I've lost count of the number of times I've been told to orbit around my local airport, due to incoming airliners or offshore helicopters. This was usually at the end of the downwind leg, though.
It's part and parcel of learning and then operating. Just a personal view! |
Originally Posted by 18greens
(Post 11618679)
Southend? 2006? Very unfortunate..
For those who don't know it, a student fatality while instructed to make an orbit when already lined up and configured for finals. Second solo. Instructor and family watching ... Cessna F150L, G-BABB, 19 July 2006 - GOV.UK (www.gov.uk) |
All times are GMT. The time now is 12:07. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.