Go Back  PPRuNe Forums > Aircrew Forums > Flying Instructors & Examiners
Reload this Page >

Ab initio training on SEP - 10 yr restriction re engine overhaul

Wikiposts
Search
Flying Instructors & Examiners A place for instructors to communicate with one another because some of them get a bit tired of the attitude that instructing is the lowest form of aviation, as seems to prevail on some of the other forums!

Ab initio training on SEP - 10 yr restriction re engine overhaul

Thread Tools
 
Search this Thread
 
Old 13th Sep 2012, 10:44
  #1 (permalink)  
Thread Starter
 
Join Date: Jul 2010
Location: UK
Posts: 156
Likes: 0
Received 0 Likes on 0 Posts
Ab initio training on SEP - 10 yr restriction re engine overhaul

Could anyone direct us to the regulations restricting ab initio pilots soloing on a SEP which is over 10 years from engine factory overhaul?

The engine in question is almost zero-time (routine maintenance), but we understand there is a slightly obscure 10yr rule restricting ab initio pilots.

Last edited by FlyingGoat; 13th Sep 2012 at 13:04.
FlyingGoat is offline  
Old 13th Sep 2012, 13:03
  #2 (permalink)  
 
Join Date: Mar 2009
Location: Scotland
Posts: 381
Likes: 0
Received 0 Likes on 0 Posts
It's not specifically about ab initio training but relates more to the rent or reward from the aircraft. You may not use an engine that is 10 years old + 20% for commercial purposes can't remember where that is specifically .

If you own the plane and aren't actually gaining anything from the use of the plane then it's entirely possible that the CAA will allow you to train on an aircraft with an engine older than 10 years. Give them a call and ask.
Dan the weegie is offline  
Old 13th Sep 2012, 13:11
  #3 (permalink)  
Thread Starter
 
Join Date: Jul 2010
Location: UK
Posts: 156
Likes: 0
Received 0 Likes on 0 Posts
Many thanks for that. I can't find the relevant documentation, and I haven't yet found anyone at the CAA (licensing? training? airworthiness?) who understands the question, which is perhaps my fault. We're a non-profit flying club and the a/c is purely for our members' use.

Last edited by FlyingGoat; 13th Sep 2012 at 13:14.
FlyingGoat is offline  
Old 13th Sep 2012, 14:00
  #4 (permalink)  
 
Join Date: May 2006
Location: uk
Age: 60
Posts: 30
Likes: 0
Received 0 Likes on 0 Posts
CAP 747, GR 24
chanter is offline  
Old 13th Sep 2012, 14:20
  #5 (permalink)  
Thread Starter
 
Join Date: Jul 2010
Location: UK
Posts: 156
Likes: 0
Received 0 Likes on 0 Posts
Thanks, Chanter - I've researched GR24, but can't see the specific reference to our situation or minimum pilots' qualifications - any further clues on which is the paragraph(s)? Is it in the appendices? I've tried various keywords.

Last edited by FlyingGoat; 13th Sep 2012 at 16:04.
FlyingGoat is offline  
Old 13th Sep 2012, 14:55
  #6 (permalink)  
Moderator
 
Join Date: Feb 2000
Location: UK
Posts: 14,221
Received 48 Likes on 24 Posts
http://www.caa.co.uk/docs/33/ORS4_899.pdf

Does not contain the answers, but may help point you in the right direction.

G
Genghis the Engineer is offline  
Old 13th Sep 2012, 16:04
  #7 (permalink)  
 
Join Date: Mar 2009
Location: Scotland
Posts: 381
Likes: 0
Received 0 Likes on 0 Posts
FlyingGoat, I think you'll not be able to do it in that case.
You're still renting the machine to someone for profit or no and that incurs a level of liability that isn't there if you own the machine and are learning on it.
It's really not that obscure a rule.

If Licensing can't help you then Airworthiness ought to know. But licensing should be the ones imo as they also deal with the Registered Training Facilities - don't expect a quick answer though.

The bit that you're looking at is 3.1.2. It's aerial work.

Last edited by Dan the weegie; 13th Sep 2012 at 16:09.
Dan the weegie is offline  
Old 13th Sep 2012, 16:07
  #8 (permalink)  
Thread Starter
 
Join Date: Jul 2010
Location: UK
Posts: 156
Likes: 0
Received 0 Likes on 0 Posts
Thanks, Dan. I was hoping to get an answer from the CAA Tech. Standards Surveyor (?), but I guess they've more important queries - I was hoping for a straight yes or no in black and white.

Last edited by FlyingGoat; 13th Sep 2012 at 16:08.
FlyingGoat is offline  
Old 13th Sep 2012, 16:20
  #9 (permalink)  
 
Join Date: Mar 2009
Location: Scotland
Posts: 381
Likes: 0
Received 0 Likes on 0 Posts
So first CAP747 GR 24 3.1.2
Engines that have complied with paragraphs 3.1 and 3.1.1, and have completed 120%
of the recommended operating time or calendar time, whichever occurs first, may
continue in service indefinitely, subject to compliance with a), b), c) and d).
a) The engine being installed in an aircraft which is not used for the purposes of
Public Transport or Aerial Work.
b) Compliance being shown with the appropriate limitations specified in Appendix
No.1 paragraph 5, to this Generic Requirement.
c) The engine being inspected in accordance with paragraph 4 in order to assess its
condition before exceeding 120% of the recommended operating time or calendar
time, whichever occurs first, and subsequently being inspected and re-assessed
at 100 hour or yearly intervals, whichever occurs first.
d) The data obtained during the inspections of paragraph 4 being entered in the
engine log book. A log book entry should also be made to restrict engine usage
during this extension period to flying for the purposes of Private Flight only


Then from the ANO Article 259
Meaning of aerial work

259.—(1) Subject to paragraph (2) and Part 34, aerial work means any purpose, other than commercial air transport or public transport, for which an aircraft is flown if valuable consideration is given or promised for the flight or the purpose of the flight.

(2) If the only such valuable consideration consists of remuneration for the services of the pilot the flight is deemed to be a private flight for the purposes of Part 3 and Part 4.

(3) Aerial work consists of instruction or testing in a club environment if it consists of the giving of instruction in flying or the conducting of flying tests for the purposes of this Order in an aircraft owned by, operated by or operated under arrangements entered into by a flying club of which the person giving the instruction or conducting the test and the person receiving the instruction or undergoing the test are both members
The definite answer is no,
Unless you have an engine that doesn't have an age defined by the manufacturer. Which if it's a club aircraft will be a lycoming or a continental and they are mostly 10 years + 20% so max 12 years old.

The ONLY thing you can do, is to have people buy a share in the aircraft and have them pay an instructor separately to teach them on the aircraft as I believe that is almost certainly private use - but I'm not convinced
Dan the weegie is offline  
Old 13th Sep 2012, 16:26
  #10 (permalink)  
Thread Starter
 
Join Date: Jul 2010
Location: UK
Posts: 156
Likes: 0
Received 0 Likes on 0 Posts
That's brilliant, Dan - very much appreciated.
FlyingGoat is offline  
Old 13th Sep 2012, 22:35
  #11 (permalink)  
 
Join Date: Mar 2005
Location: THE NORTH
Posts: 299
Likes: 0
Received 0 Likes on 0 Posts
What engine?

Continental and Lycoming engines have a recommended tbo of 12 years + 20% here in the UK under Gr24 so it's 14.4 years.

What engine is it and where are you getting 10 years from?
JUST-local is offline  
Old 14th Sep 2012, 09:17
  #12 (permalink)  
Thread Starter
 
Join Date: Jul 2010
Location: UK
Posts: 156
Likes: 0
Received 0 Likes on 0 Posts
The engine's a Continental O-200-A and we're a 'registered facility'. More info being researched....
FlyingGoat is offline  
Old 14th Sep 2012, 09:29
  #13 (permalink)  
 
Join Date: Mar 2005
Location: THE NORTH
Posts: 299
Likes: 0
Received 0 Likes on 0 Posts
0-200-A

We also operate the same also through a registered facility and they have a TBO of 12 years or 1800 hours + 20% under the conditions or GR24 as mentioned above.

So you you do have up to 2160 hours and 14.4 years.

Last edited by JUST-local; 14th Sep 2012 at 09:37.
JUST-local is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.