Notices
Flight Testing A forum for test pilots, flight test engineers, observers, telemetry and instrumentation engineers and anybody else involved in the demanding and complex business of testing aeroplanes, helicopters and equipment.

question

Old 2nd September 2003 | 12:51
  #1 (permalink)  
Thread Starter
 
Joined: Jul 2002
Posts: 358
Likes: 0
From: australia
question

if you take off in a single engine prop aircraft with a c of g aft of the c of p and find that full fwd stick won't stop the nose from rising, will a reduction in power help or will the reduced airflow over the elevator worsen the situation? Also, how will different flap positions affect the situation?
PS I'm not planning on experimenting but have recently read of someone who found themselves in this situation!
cjam is offline  
Old 2nd September 2003 | 15:17
  #2 (permalink)  
Moderator
30 Countries Visited
25 Anniversary
Veteran: Reserves
 
Joined: Feb 2000
Aviation Qualifications: CPL
Posts: 14,480
Likes: 178
From: UK
Well my brief opinion over breakfast...

I'm not sure I fully understand what you mean by CP in this context, I suspect that you actually mean CG aft of the aft CG limit?

As a situation, what you describe seems feasible, the subsequent actions are very dependent upon aircraft design.

For example, if you've got a type with a very high thrustline, then power will probably help - alternatively with a very low thrustline then cutting the power will help - this is just all about moments about the vertical CG.

Wash over the tailplane is a less clear issue - but lets say you have got a lot of propwash over the tailplane. In that case, increased power should make the tailplane ,more effective and may aid the pilot in getting the nose down.

Flaps - not sure, I've seen flaps both stabilise and destabilise an aeroplane in pitch (both high-wing / low tail aeroplanes). I'm sure there's some theory out there which describes what SHOULD happen, but my experience it's never as simple as theory would have you believe for which reason I'll pass on that one.

G
Genghis the Engineer is offline  
Old 3rd September 2003 | 15:24
  #3 (permalink)  
Thread Starter
 
Joined: Jul 2002
Posts: 358
Likes: 0
From: australia
Cheers Ghengis,

What I meant was the center of pressure. Your post was all good 'food for thought' though, thanks. I am pretty sure the a/c was a low wing but not sure on the thrust line. I'll have a re-read and see if I can find out.

Cjam
cjam is offline  
Old 8th September 2003 | 03:42
  #4 (permalink)  
50 Countries Visited
20 Anniversary
Veteran: Air Force
 
Joined: Jun 2002
Aviation Qualifications: PPL
Posts: 5,106
Likes: 323
From: east ESSEX
I would suggest if you got/ get airborne in a configuration where the CofG is beyond the aft limit, then you do not make any large/ sudden inputs on any controls/ change power gently /dont alter flaps/gear. The aircraft will be close to being unstable longitudinally, and could diverge in pitch, nose-up/down.
Fly very gently around and get it on the ground
Lateral/directional stability will also be affected, so it must be flown carefully,as balanced as possible and as smoothly as possible. Most a/c will be able to cope with the CofG behind the aft limit; they will have been tested , and normal limits will be inside those boundaries.
Then, back on the ground, go back and do the calcs. again!!!
sycamore is offline  
Old 2nd October 2003 | 15:32
  #5 (permalink)  
Morning Calm
 
Joined: Jul 2002
Posts: 12
Likes: 0
From: Farnborough
Well, one way to get the nose to drop is to roll on bank. Some years ago an A300-600 got airborne with c of g aft of the limit, and the pilot, having run out of other ideas (elevator/stabilizer/flaps), applied 40 degrees of bank and flew around in circles until the fuel could be transferred to remedy the problem. Sounds bizarre, but it saved the day. Of course, if this doesn't work then you're probably headed for a spin!
Just goes to show how important the trim sheet is.............
Chosun is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.