Notices
Engineers & Technicians In this day and age of increased CRM and safety awareness, a forum for the guys and girls who keep our a/c serviceable.

Radalt characteristics

Old 18th February 2011 | 06:21
  #21 (permalink)  
 
Joined: Jan 2011
Posts: 217
Likes: 0
From: on the cusp
Do you have any information about the angle of the cone of the signal
The radalts I have worked with are comfortable with a composite attitude angle of around 45°. This would roughly correspond to the half cone angle. I have to say that this is a general observation and is very much dependant on individual units, and their antenna designs and placements.

Would it be right therefore to conclude that radalt would be highly accurate at low altitude over relatively smooth terrain no matter how high the ground speed?
I think that is generally correct, in level flight over a "smooth" reflective surface the ground speed would have little to no effect.

Errors come from a variety of sources, modern radalts are very good at coping with scatter and multi-path effects. They are also largely doppler immune. By design they look for the leading edge of a valid return signal to try and give the closest point and not the slant angle. Therefore if the ground is closer than the slant range to the building then it will still track the ground. There are also filters that prevent sudden large changes of altitude, such as when passing over another aircraft. Accuracy is generally given as a percentage so therefore the lower you are the more accurate the reading. Although there is a lower cutoff due to the limit of technology that gives an absolute measurement accuracy usually around ±3 ft. Because a descent rate is seen directly by the altimeter excessive descent rates can degrade the accuracy as well.
dClbydalpha is offline  
Reply
Old 18th February 2011 | 08:04
  #22 (permalink)  
Thread Starter
 
Joined: Jan 2011
Posts: 78
Likes: 0
From: Australia
Thanks for that. It seems I need to refine the angle question a bit. The footprint may not be circular. It is the roll angle that I was wondering about. Do you know the angle from vertical of the outer edge of the beam, side-on to the direction of travel?
gravity32 is offline  
Reply
Old 18th February 2011 | 08:43
  #23 (permalink)  
 
Joined: Jan 2011
Posts: 217
Likes: 0
From: on the cusp
Unfortunately I don't, sorry.
For an approximation of the radalts I know, I'd assume it is circular and at 45°. The tech specs that I have don't specify individual angles, just an overall angle limit. But looking at the TSO it sepcifies a test limit in roll that is greater than in pitch, which makes sense in operation.
dClbydalpha is offline  
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.