Arriel 1C1 required
Thread Starter
Joined: Jul 2000
Posts: 1,735
Likes: 21
From: Used to be God's own County
Arriel 1C1 required
Looking for an Arriel 1C1 for as365N1 use, any pointers apart from the obvious appreciated.
Must have Easa/JAR Form 1 release.
Long and short of it is that Turbomecca cannot offer anything except a part-ex on another engine.
We have an engine that is making metal (not enough to set chip-light off) but detected by engineer.
Spectro analysis confirms metal from a bearing in one of 3 modules.
Turbomeca cannot/will not provide loaner whilst investigation underway to confirm actual cause.
Quoting 16-20 weeks for repair.
Their idea of AOG repair is to offer engine replacement for what could be a single bearing failing.
Ironic thing is we were no more than a week away from being signed up to PBH!!!!!!!!!! (and that was only because Turbomeca were slow with the quote)
Thank god for being on a salary.............
Must have Easa/JAR Form 1 release.
Long and short of it is that Turbomecca cannot offer anything except a part-ex on another engine.
We have an engine that is making metal (not enough to set chip-light off) but detected by engineer.
Spectro analysis confirms metal from a bearing in one of 3 modules.
Turbomeca cannot/will not provide loaner whilst investigation underway to confirm actual cause.
Quoting 16-20 weeks for repair.
Their idea of AOG repair is to offer engine replacement for what could be a single bearing failing.
Ironic thing is we were no more than a week away from being signed up to PBH!!!!!!!!!! (and that was only because Turbomeca were slow with the quote)
Thank god for being on a salary.............
Last edited by EESDL; 5th July 2007 at 19:08.
