pilot_will
12th Jun 2003, 18:07
Hiya, I was wondering if a 737-300 or 400 pilot could answer this please.
On flight sim when I have the FMC set with all the N1 speeds and the VNAV speeds. I press toga mode to set the N1, and on the climb out at about 1000 feet I press VNAV, but then I see 300 kts on the EADI, insted of 220 (which I normally choose for initual climb speed), and so climbing at 300 kts is breaking the noise procedure.
When this happens I need to then try and select VS and control the speed normally until I pass fl100.
Just wondering if you could advice me on what to do please.
Many thanks.
On flight sim when I have the FMC set with all the N1 speeds and the VNAV speeds. I press toga mode to set the N1, and on the climb out at about 1000 feet I press VNAV, but then I see 300 kts on the EADI, insted of 220 (which I normally choose for initual climb speed), and so climbing at 300 kts is breaking the noise procedure.
When this happens I need to then try and select VS and control the speed normally until I pass fl100.
Just wondering if you could advice me on what to do please.
Many thanks.