View Full Version : Holding pattern questions
FlyingStone
24th Nov 2011, 07:25
Correct. The actual reference should be to ICAO Doc 8168, Vol. 1:
1.4.1 The entry into the holding pattern shall be according to heading in relation to the three entry sectors shown
in Figure I-6-1-2, recognizing a zone of flexibility of 5° on either side of the sector boundaries.
dontdoit
24th Nov 2011, 12:49
Since it's a long, long time since I did my initial IR, my co-pilot today asked me about holding patterns, hold entries and the like and I honestly didn't know the answer.....I defer therefore to you, my younger and wiser friends:
- What is the tolerance between sectors for entry eg if on the "boundary" between sectors entering the hold?
- What governs where the boundary falls wrt the entry, track inbound or heading inbound?
Thanks in advance!
Da-20 monkey
24th Nov 2011, 15:26
1. 5 degrees flexibility
2. magnetic heading relative to holding course
reference: oxford air law book and jeppesen ICM.
(I looked it up just to be sure:rolleyes:)
dontdoit
24th Nov 2011, 17:58
Thanks guys, much appreciated !