PPRuNe Forums - View Single Post - using non approved harware for panels
Thread: using non approved harware for panels
View Single Post
Old 10th Feb 2017, 10:14
  #20 (permalink)  
matkat
 
Join Date: May 2004
Location: Balmullo,Scotland
Posts: 933
Likes: 0
Received 0 Likes on 0 Posts
If this was done as stated by the OP then this hardware would not have been approved therefore rendering them 'suspected unapproved parts' which would cause for immediate grounding along with an MOR.
matkat is offline  
Reply