PPRuNe Forums - View Single Post - A320 protection
Thread: A320 protection
View Single Post
Old 13th Oct 2016, 13:43
  #6 (permalink)  
vilas
 
Join Date: Jun 2007
Location: Wanderlust
Posts: 3,407
Likes: 0
Received 0 Likes on 0 Posts
Since it meets the climb gradient requirement even when overweight the AOA will no reach Valphaprot to trigger that protection. Quoted below from FCTM on over weight go around:
If aircraft weight is above the maximum weight for go-around in CONF 3, landing will be performed CONF 3 (and go-around CONF 1+F). The CONF 1+F meets the approach climb gradient requirement in all cases (high weights, high altitude and temperature).
If a go-around CONF 1+F is carried out following an approach CONF 3, VLS CONF 1+F may be higher than VLS CONF 3 +5 kt. The recommendation in such a case is to follow SRS orders which will accelerate the aircraft up to the displayed VLS. It should be noted, however, that VLS CONF 1+F equates to 1.23 VS1G whereas the minimum go-around speed required by regulations is 1.13 VS1G. This requirement is always satisfied



Last edited by vilas; 13th Oct 2016 at 13:53.
vilas is offline