After reading this thread I took the liberty to pay more attention to it the next flight. Just to share with you. This was the sequence.
Clean Config ---- VFe 240 (= for F1)
Selecting F1 ---- slats only extend ----- VFe 215 (= for F1+F)
Selecting F2 ---- initially the slats extend to 2 + VFe is 205 (= for F2* = Slats 2 but flaps still as 1+F) speed is in the meanwhile decreasing and flaps are extending. Once flaps passes position 1 the speed is below 196 and VFe becomes 196 (= for F2). Now flaps continue to position 2.
If the speed does not decrease. The FLRS will prevent the flaps to retract to position 2 and the VFe will remain on 205.
Hope it helps.