More Q's
More q's from this months awful systems exam
1. How is a starter motor connected?
A) Series wound
B) Shunt wound
C) Compound wound
D) Wounded up
2. What happens to the temp, pressure and velocity in a centrifugal compressor?
A) Temp decrease, pressure decrease, velocity increase
B) Temp increase, pressure increase, velocity decrease
C) Temp, pressure and velocity increase
D) ???
3. What happens when you put the magneto switch to OFF?
(it could have been ON, tho i think there was another question similar in layout talking about what happens when it is ON)
A) Secondary circuit grounds
B) Primary circuit opens
C) Secondary circuit opens
D) Primary circuit grounds
4. Before entering a pump why is the fuel slightly pressurised?
A) To prevent vapour locks
B) To prevent pump cavitation
C) ??
D) ??
5. What is the order of a bootstrap system?
A) Primary heat exchanger, secondary heat exchanger, turbine, compressor
B) Primary heat exchanger, compressor, secondary heat exchanger, turbine
C) ????
D)????
I got this one using 'Pamela's C*** Smells Terrible'
6. What is the correct arrangement in an axial flow compressor?
A) Stator, rotor, stator
B) Rotor, stator
C) Stator, rotor
D) Rotor, stator, rotor