Let 410 Control Surfaces - require some info please
Hi everyone,
I'm tasked with suggesting possible improvements/ alterations for the control surfaces on the Let 410 to increase a/c sustainability.
I know this is very very vague. It's a university group project so I will not be building real prototypes!
I find it rather difficult to write anything about possible improvements of the control surfaces. If it was avionics or engines it would be much easier. But I'm stuck with this I'm afraid so if any of you have any possible suggestions or even something I could discuss like possible issues/ constraints/ why you can or cannot change this or that - this can relate to anything from type of material used, to the hinges, to the cables, to surface area, dimensions and shapes, cost of production/ servicing etc. Possible alterations of the wings, fin, tail plane are also allowed to increase the a/c sustainability.
Once again, non of this has to be backed up by equations. It's more about discussing what could be done...
Any suggestions much appreciated!
Thanks