Hi,
H jcjeant.
From 02 10 15 the roll input is L & R (-8 to + 8) with little back stick.
From 02 10 45 to 02 11 30 the back stick varies between 0 and -10, at the same time the stab trim runs from -3 to -10.
From 02 11 30 onwards the back stick is held between full back (-30) to about half back but mostly full back; from 02 11 30 to 02 11 45 the stab trim runs to the limit -13 and remains there.
Maybe I'm not enough smart for read a graphic ..
But I was requesting advise cause I see differences between the stick position and surfaces position in a corresponding time (discripancies) and I don't think it's can be caused by some hysteresis ...
I read some big movements of the stick .. and not corresponding movement of elevator (at same time)
Why this gap ? (at least is what I see in the graphic)