Yes, really. You obviously don't understand the terminology -
rotarywise,
...yes, maybe I should have explained myself [slightly] more comprehensively and been more careful with my 'Approved(s)' and my 'Accepted(s)'. I was using the word 'approved' rather than 'accepted' as it appears in
SRG/1173 , in the title of page 4, to indicate a course that was not approved by the CAA but would be accepted through the JAR/JAA references [et al] you listed. Thanks for the link to
Standards Document 31 - most informative.
Yours, in mutually appreciative pedantry...Zulu
hihover,
Thanks for spotting that my lexicon was out of sorts and substituting more suitable terminology as required!
Sadly, the UK CAA will not issue you a JAA ATPL(H) based on the AW 139.
This is dissapointing/annoying/means
Lidl shopping for a while (couldn't resist a link - Arc Welders are on special this week!).
Whilst I realise (hope) that your
...note from your mum...
was tongue-in-cheek and that I might be clutching at straws here, is there any milage in the Ops Manual ref?
I have a few more references that I'd like to throw back at this to see how I am mis-interpreting them.
Zulu