PPRuNe Forums - View Single Post - Concorde question
View Single Post
Old 30th Jan 2011, 09:38
  #1154 (permalink)  
M2dude
 
Join Date: Jan 2008
Location: FL 600. West of Mongolia
Posts: 463
Likes: 0
Received 0 Likes on 0 Posts
Talking Engine Bay

Pen Pusher
That really is a superb photo and shows just what a large but cramped affair the Concorde engine bay was. Although a pre-producion example, the picture generally shows what the production aircraft looked like inside the chasm. In the picture you can see the titanium roof of the engine bay that did such a good job in protecting the wing above (as was the case with the OAF engine failure in 1980 mentioned previously in this thread). What is missing from the 101s engine bay shown here are the air conditioning primary and secondary heat exchangers that were fitted above the engines. (The large trunking you can see coming forward from the jet pipes are the exhausts for the ram air from the exchangers). On a blunty, the heat exhangers are mounted in the belly of the aircraft, in what is generally known as a pack. But there was no room in Concorde for such lumpy bits, and so the only alternative was to mount them above the engine. The remainder of the equipment, the Cold Air Unit (or Air Cycle Machine as the blunties call them) as well as the, unique to Concorde, Fuel heat exchanger were mounted in the wings. With everything so sprawled about it could not really be called a 'pack' and so in Concorde we refered to an air conditioning GROUP.
The wiring you can see on the lower parts of the engine doors is generally Graviner fire wire, used for engine fire and nacelle overheat detection. At the forward part of the 2 doors (shown most clearly on the #4 engine) are two orange 'boxes. These are the engine bay ventilation 'ground running flap' electrical actuators (the flaps themselves being shown shut). Normally these spring loaded flaps would be open on the ground, being progreesively closed with increasing speed as engine bay pressure increased. The actuator would only run when the engine fire handle was pulled, to help seal off the bay. All the other orange stuff you can see is FTD, or flight teast wiring and equiment. (We used to not very kindly refer to it as 'orange s--t' ).

With regard to aircraft 204, G-BOAC I think you will find that all the engines are still installed. I took this photo (oops sorry, my wife did ) when we had a function in Manchester about 18 months ago. You can see what a wonderful job the folk up there are doing taking care of her, and as for dining under the wing.. it was truly a memorable experience indeed.



Best regards
Dude
M2dude is offline