My way is shorter and doesn't screw up the monitors. Codeco is all about running the monitors and doing things in sequence. If you do entries out of sequence, the monitors get stuck and the system doesn't work properly, especially when you try to PD the flight. Assuming all the previous monitors have been run correctly, to close out and loadsheet you only need to do
FC close flight
MO onloads any standbys
MS starts the monitors
SS shuts down system to prepare loadsheet
LS produces loadsheet
Then to PD
**MC/S/6 Runs final monitor actions
NN Release control of flight and send Load Message etc
@Y To confirm release of control
I've just found that if you do it this way the system works better!
Last edited by Dropline; 4th May 2009 at 00:18.