Maybe this will help
Bell 206 CheckList..
Cowls and latches secured,boot closed,all covers removed,rotor Untied.
PRE START....
Weight and balance - Checked.
Doors - Secure
Pedals - Adjusted
Harness - Secure
Flight Controls - Full and Free Movement
Neutral,Frictions ON!
Throttle - Checked/Closed
Battery/Aux Power - On/Conected
Landing Light - Off
Beep Switch - Decrease
Anti Ice - Off
Hydraulics - ON
Fuel Valve - ON
Radio's/ Avionics - SET
Engine Instruments - Condition,TOT Noted
Flight Instruments - Condition, Alt-set
Generator - OFF
Other Switches - Off
Overhead CB's - IN
Warning Lights - Test
Low RPM Warning - Test (if fitted)
Fuel Boost Pumps - Checked
START..
Rotors - Clear & Untied
Anti-Collision Light - ON
Starter - Engage
OIL Presure - Rising
TOT - At or Below 150 Degree;s
At 15% N1 - Throttle Idle
TOT - Monitor
By 25% N1 - Rotors Turning
58%-60% - Release Starter
Eng/Xmsn Oil Preesure - Check
Check - TQ,N1,-2 TOT, (idle 60%-62%)
Aux Power - Disconnect,Battery On
After 1 Min at Idle - N1 70%,greater ON (note Load)
Radios.Avionics - On and Set
Control Frictions - OFF
Flight Controls - Checked
Hydraulics - Checked
Throttle - Fully Open ( Torque Below 30psi)
Beep Range - Check 97-100,set 100%
Hope this helps!!
