Hi Elroy,
this will have to be a brief post just to give you a starter, I will try to sort out more later (work permitting!!)
N1 is easy - try looking for 'phonic-wheel' sensors : basically a winding on a magnet detects a cog wheel's teeth going past - same principle that a guitar pick-up uses. Electrically, the output is amplified, pulse-shaped and frequency detected to produce a signal output proportional to speed input.
Alternative methods sense the frequency of a dedicated alternator if there is a power take-off from that shaft this is usually not the N1 shaft though!
<edit>
http://www.westonaero.com/products/h...ed_sensors.stm
EPR uses two pressures, the inlet duct pressure and the output jet exhaust pressure. These are sensed by using (in my case) 'oscillating cylinder' transducers. These are a cavity which is piped to the zone in which the pressure needs to be sensed with have an exciter winding and a sensor winding and vibrate a natural frequency which is pressure dependent. An amplifier keeps the oscillation going and a sensor and frequency to voltage converter produces the output. This needs to be compensated for temperature and other effects. Each transducer usually comes with its own calibration tables (dammit - if one breaks it makes life awkward reporgramming) - search manufacturers Solatron, Druck and Kulite.
VnV...