PPRuNe Forums - View Single Post - PC-Linq problem...
View Single Post
Old 20th Jan 2005, 14:54
  #1 (permalink)  
cool blue
 
Join Date: Jul 2001
Location: uk
Posts: 52
Likes: 0
Received 0 Likes on 0 Posts
PC-Linq problem...

I am trying to install a "NetLink/Directlink", file/data transfer cable (i.e. the "host to host" or "direct-linq" part, not the "network" bit). I believe the chipset is a Prolific PL-2301. The installation runs without problem completing with an icon named "PC-Linq". When the program is then run the red indicator lights are on for both the local and remote machines (indicating USB not connected). After poking around I find that a new conflict has occurred (yellow question mark) in System Properties called "Other devices" , along with a sub-headed "USB Host To Host Bridge" entry (also flagged yellow question mark).

I've uninstalled & reinstalled several times (using add/remove programs) to little avail save, on occassions (either boot-up or cable entry) the "Windows has detected a new hardware device" wizard appears. "USB Host to Host Bridge" does appear, in the devices window etc, but concludes by saying "the device is already installed but it has a problem" ... see device properties...where it says "the drivers for this device are not installed (code 28)". Option to re-install driver>wizard again>two options 1."search better driver recommended" results as above, and 2. "Direct wizard to list of specific drivers" etc, after which the result is "Windows was unable to locate a driver for this device". Press finish> says "Unknown device" with yellow question mark.

I've also tried right-click on the driver where an install option is... nada again.

It looks like windows can see the device but can't properly recognise thus install it. I've downloaded the driver (Usbbc.inf) and program from around half a dozen sites in case the driver was corrupted, but no luck.

Finally, I tried installing the network drivers, but that didn't work either (it didn't even recognise each local machine).

Is it possible to sneak the driver in past windows using DOS? (But where would it go?)

Would much appreciate any help offered.

C.B.

[PC: AMD-K6(tm) 3D MMX 3Dnow, 500mhz, 128ram, Win98SE & Laptop: AMD-K6-111, 466mhz, 64ram, Win98SE]

Last edited by cool blue; 20th Jan 2005 at 21:29.
cool blue is offline