Entry out of range scratchpad A320
Hello guys,
Twice I had the same issue on A320 Neo. ATC asked us to descend to FL240 by waypoint XXX. We were cruising at FL390. I tried to enter FL240 as a constraint in the waypoint XXX but it does not accept it and the message « Entry out of range » is displayed. Any idea why? The vertical speed required to comply with the constraint was only 1200 feet/ min. I can’t remember how many track miles to destination were remaining but quite a lot. Not sure if it has to do with the cruise phase. I had this issue twice at 2 different flights and both on Neos.
Also did you notice when you insert a ‘direct to’ waypoint,it sometimes go to the alternate route page on the opposite MCDU. Funny glitch and could not find anything about it on the FCOM either.
Last edited by pineteam; 6th Nov 2019 at 00:49.
Reason: Typo