INTERPRETATION of word "TRANSIT"
As A 320 or 330 Pilots are well aware, AFTER LANDING proecdures states
On ground, hot weather conditions may cause overheating to be detected around the bleed ducts in
the wings,On ground, hot weather conditions may cause overheating to be detected around the bleed ducts in
the wings, resulting in “AIR L (R) WING LEAK” warnings. Such warnings may be avoided during
transit by keeping slats in CONF 1, when OAT is above 30 °C. resulting in “AIR L (R) WING LEAK” warnings. Such warnings may be avoided during transit by keeping slats in CONF 1, when OAT is above 30 °C.
Based on the logic of this proecudre, here I interpret the word TRANSIT, as any time period that the airplane stays on ground at mentioned condition. However some people interprets this word is as the flight state where Transit CL steps are implemented. This sounds me very illogical as looking at the reason of this procedure is advised..
I am looking forward the comments from PPRUNE, where I beleive many more professionals exists than where I work.
Regards
Last edited by JABBARA; 2nd Aug 2019 at 16:23.
Reason: Font